User manual SONY RM-VZ950T

[. . . ] Erasing all memorised settings from a Setting position number . The RM-VZ950T Remote Commander provides centralised control of all your AV components from a single remote commander and saves the trouble of operating different AV components with different remote control devices. Centralised control of Sony AV components with this one remote commander This Commander is preset at the factory to operate Sony brand components, so you can use it out of the box as a control centre for your Sony AV components. You can remote control your components by setting their code numbers (page 8). [. . . ] (For example, if the volume becomes very loud after pressing 2 + only once, noise may have interfered during the Learning procedure. If you set a component code after "learning" a signal If you have programmed any signal on a button by the Learning function, that signal will work even after you set a component code. If "NG" flashes twice, and the component name flashes again You can only "teach" to one button at a time. Therefore you cannot teach a sequential button operation (for example REC z + N) to a single button on your Commander. Do not move the remote units during the Learning procedure. ⷠBe sure to keep holding down the "learning" button until your Commander reacts as described. ⷠUse fresh batteries in both remote units. ⷠAvoid Learning in places under direct sunlight or a strong fluorescent light. ⷠThe remote control detector area may differ depending on each remote unit. If Learning does not work, try changing the positions of the two remote control units. ⷠWhen you "teach" signals of an interactive signal exchange system remote control unit (supplied with some of Sony's receivers and amplifiers) to the Commander, the response signal of the main unit may interfere with the Learning of the Commander. In such a case, move to a place where the signals will not reach the main unit (e. If you have programmed any signal on the 2 +/­ or button for "TV" or "AMP" using the Learning function, that signal will not be transmitted. To use "learned" signals, you need to program the 2 +/­ or buttons for each component using the Learning function. You can also press OK instead of pressing the Jog dial. At the factory, the Commander is preset to change the component in the following order. However, you can change the order as you like. In some cases, a processing indicator (see Notes on page 22) might appear in the display. You can also press b/B instead of turning the Jog dial to the left/right. You can also press OK instead of pressing the Jog dial. Example: To move "VCR" between "TAPE" and "AMP" Component in front of where you want to set the selected component. While you scroll through the menu, all other component names also flash rapidly. [. . . ] If you have changed the component selection order, the components are selected in the changed sequence. To change the component selection order or component names, see "Changing the Component Selection Order (MOVE)" on page 24, or "Changing the Name of the Component (NAME)" on page 26. To reset the Commander to the initial factory preset, see "Erasing all memorised settings from the Commander-- Factory Reset" on page 31. If none of the above have solved your problems, try resetting the Commander to the factory setting (page 31) before contacting any Customer Support. [. . . ]