User manual SONY RM-X2S

[. . . ] Two button name labels are supplied with the rotary commander. The following buttons and controls (except the SOURCE and MODE button) share the same functions as those on the master unit or the wireless remote commander. [. . . ] SEL button Functions in the same way as the SEL button on the master unit. ) During radio reception: Receives the stations memorized on the preset number buttons on the master unit. Note on Operative Directions of the Rotary Commander Controls Assuming the rotary commander to be installed on the left of the steering column, the operative directions of the VOL, SEEK/AMS and PRESET/DISC controls were factory-set so that turning left corresponds to the + direction (A). If the installation position should require it, the operative direction of the VOL, PRESET/DISC and SEEK/AMS controls can be reversed. To reverse, press the SEL button for at least two seconds while pressing on the VOL control (B). (Pressing the reset button on the master unit will restore the original setting. ) When the POWER SELECT switch on the master unit is set to position B, you can turn on the master unit by pressing the SOURCE button on the rotary commander. Choose the mounting location carefully so that the rotary commander will not interfere with operating the car. Do not install the rotary commander in a place where it may jeopardize the safety of the (front) passenger in anyway. When installing the rotary commander, be sure not to damage the electrical cables etc. Avoid installing the rotary commander where it may be subject to high temperatures, such as from direct sunlight or hot air from the heater etc. Choose the exact location for the rotary commander to be mounted, then clean the mounting surface. [. . . ] Be sure to leave some slack in the connecting cord between the plug and the cramper as illustrated. När du är klar fäster du ihop sladden till vridkommandot och andra sladdar till ljudutrustningen med medföljande krampa C. [. . . ]