User manual SONY RMO-S551

[. . . ] The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. [. . . ] Note If the disk unit is the last device on the SCSI chain, set function switch F to "1" to turn on the internal terminator. When it is not the last device, make sure that the terminator is off (switch F is set to "0"). If the disk cartridge cannot be ejected using the EJECT button 6, turn off the power and insert the supplied emergency eject tool into this hole to trip the emergency eject mechanism. Refer to the section "What to do if the disk does not eject" on page 12 for further details. The air for cooling the disk unit flows through this duct, so be careful not to block its surface or impede the outflow. Connect the ground terminals of other devices to the disk unit's frame ground. Press this button to eject the disk cartridge from the disk unit. the EJECT button is disabled with the function switch or software settings prohibit ejection. When the write cache is enabled, it may take a few moments (up to 45 seconds) for the disk to eject because data in the cache must first be written to the disk. Connect the supplied AC power cord to this connector. Before setting up your RMO-S551 MagnetoOptical Disk Unit, check to see that you have all the required components and accessories. Then, connect the disk unit to the host computer and any other SCSI peripherals you may be using. After checking to see that all the connections have been properly made, set the SCSI ID using the SCSI ID switch and the disk unit's functions using the function switches. Upon opening the carton, check to see that you have all of the components and accessories listed below. Contact your dealer immediately if you find any missing or damaged items. 1 Blank MO disk (EDM-5200B) Note Please refer to the installation manual included in the device driver's package for instructions when using this device with a Macintosh® computer or a computer running under Windows® system. You can hook up a maximum of seven SCSI peripheral devices to a single host computer through its SCSI bus. Use the following Sony SCSI cable to connect the disk unit. notes · Before connecting the disk unit, be sure to turn off the disk unit and all other devices on the SCSI chain. ⷠIf the disk unit is the last device on the SCSI chain, set the function switch F on the rear panel to "1" to turn on the internal terminator. When it is not the last device, make sure that the terminator is off (function switch F is set to "0"). ⷠThe total length of the SCSI cables connected to a SCSI chain must not exceed six meters (19 feet 8 1/4 inches). [. . . ] Do not use any type of solvent, such as alcohol or benzine, which may damage the finish. Do not drop the disk cartridge or subject it to any violent shocks or vibration. It is a precision component and has been carefully adjusted at the factory prior to shipment. ⷠDo not open the disk cartridge's shutter manually or touch the disk inside. [. . . ]