User manual SONY RMT-DSLR1

[. . . ] The RMT-DSLR1 is a Remote Commander made especially for the Sony Digital Single-lens Reflex Camera (referred below as "camera") provided a remote sensor. You can operate the camera using the Remote Commander. [. . . ] the recycling of the materials will help to conserve natural resources. In case of products that for safety, performance or data integrity reasons require a permanent connection with an incorporated battery, this battery should be replaced by qualified service staff only. to ensure that the battery will be treated properly , hand over the product at end-of-life to the applicable collection point for the recycling of electrical and electronic equipment. For all other batteries, please view the section on how to remove the battery from the product safely. hand the battery over to the applicable collection point for the recycling of waste batteries. For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. With the exception of the 2 SEC and SHUTTER buttons, the buttons only work when the camera is connected to a TV. Point the Remote Commander at the remote sensor on the front of the camera in order to operate the camera. 1 While pressing on the tab , inset your fingernail into the slit to pull out the battery case. 2 Remove the old battery and place a new battery with the + side facing up. 3 Insert the battery case back into the Remote Commander until it clicks. When the lithium battery becomes weak, the operating distance of the Remote Commander may shorten, or the Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion. [. . . ] Take it to the nearest Sony dealer immediately for repair. When dirty, this unit may be cleaned with a clean, dry cloth. [. . . ]