User manual SONY RMV210T annexe 1

[. . . ] In addition, the Commander can learn remote control signals (infrared signals only) of non-Audio Visual components such as air-conditioners, lights, etc. You can assign other Component Select Buttons to freely operate other components. This is useful when you have more than two of the same kind of AV components (page 35). You can programme up to 16 consecutive operation steps to execute a series of operations by pressing a single button (page 23). [. . . ] In this case, the Power-On function is overwritten and cannot be used. If you clear the System Control functions for the button, the Power-On function is resumed, and you can use it again. ⷠYou cannot programme the System Control functions for a Component Select button for which a signal has been programmed by "learning" (page 32). You can programme a signal for a Component Select button by "learning" (page 32) for which the System Control functions have been programmed. In this case, the System Control function is overwritten and cannot be used. If you clear the "learned" signal on the button, the System Control function is resumed and you can use it again. ⷠYou can programme the Power-On function (page 31) for a Component Select button for which a System Control function has been programmed, but the Power-On function cannot be used. If you clear the System Control function from the button, you can use the Power-On function. ⷠIf you interrupt the procedure at any point for over two minutes, the setting mode ends and the series of commands will be programmed to that point. In this case, clear the programme and start again from Step 1 to set the entire programme from the beginning. You can not continue from where you let off. Head with your component's remote control. About 5 ­ 10 cm (2 ­ 4 inches) away On the component's remote control (amplifier in this example) until you hear a beep. (If you release the button before you hear a beep, the signal may not be learned correctly. The name of a Component Select button for which a signal has already been learned stays lit. If you want to programme a new signal for that button by learning, clear the learned signal first (page 34). To clear the learned function of the Component Select button 1 While pressing COMMANDER OFF , press PROGRAM + and 2 +. 2 While pressing the RESET key, press the Component Select button which you want to clear. You can programme a signal by "learning" for a Component Select button for which a System Control function (page 28) or the Power-On function (page 31) has been programmed. In this case, the System Control function or the Power-On function is overwritten and cannot be used. If you clear the "learned" signal from the button, the System Control function or the Power-On function is resumed, and you can use it again. ⷠYou cannot programme a System Control function (page 28) for a Component Select button for which a signal has been programmed by "learning. [. . . ] When transferring data between this commander and another Sony RMV210T remote commander, some functions may not be able to be transferred (e. There may be some components or functions that cannot be operated with this Commander. KEY DISPLAY FUNCTION Programme down: ­ PROGRAM +/­ Programme up: + RECALL FUNCTION To turn the power on/off To change the programme Also to turn on To select doble-digit numbers. Works in the same way as the TV's commander. [. . . ]