User manual SONY RM-V60

[. . . ] If you have programmed the Channel Macro function for TV or satellite tuner operation, the button used as a macro key cannot be used for Fastext buttons. If you are using more than one amplifier and have set it on the VCR, SAT or DVD button, when selecting these buttons you cannot control the volume of the amplifier of the AMP button. If you change the setting of the AMP button to a component other than a receiver or amplifier, the volume control setting of video components will return to "TV" even if you have changed the factory preset volume control. In this case, you will not be able to control the volume from audio components other than a receiver or amplifier. [. . . ] If you have tried all the code numbers listed for your component and you still cannot get the Commander to work (or if your component is not listed in the "Component Code Numbers" table), try these steps. Z The number 5 button and the PROGR+ button each have a tactile dot for ease of use. Follow steps 1 and 2 below for each component you plan to use with the Commander. Works in the same way as your TV's commander. ZREC: To record, press N while pressing zREC. MENU: To record, press while pressing MENU. If your tape deck's commander has one set of tape operating buttons, and has an A/B button for the deck selection, use the button to select Deck A or Deck B. If more than one code number is listed, use the number that is listed first to complete the steps below. For example, if you are setting up a Philips TV, you would use the code number 086. If your component is not listed, see "Searching for the Correct Code. Set each component to the following status to enable the Search function. If all the codes fail to work (or if your component is not listed in this manual), try using the procedures in "Searching for the Correct Code. " · Check that you are aiming the Commander directly at the component, and that there are no obstructions between the Commander and the component. Make sure the batteries you are using are not worn out, and that they are inserted correctly. For example, if your component did not come with a remote commander, it is probably not capable of being controlled by a remote commander. If your video components are connected to an audio system, make sure you have set up the Commander as described in "Controlling the Volume of Video Components Connected to an Audio System. " · Should any problem persist, reset the Commander to the factory setting by pressing the 1, t and 2­ buttons simultaneously. Works in the same way as your VCR's commander. 8 To move the cursor upward, downward, to the left, or to the right. ZREC: To record, press N while pressing zREC. But you can also assign other components on these buttons. For example, if you are entering the code for a Philips TV, you would press -86. [. . . ] Q; To record, press N while pressing zREC. Power requirements Battery life Dimensions Mass 7 m (23 ft) (varies depending of the component of each manufacturer) Two size AA (R6) batteries (not supplied) Approx. Design and specifications are subject to change without notice. The validity of the CE marking is restricted to only those countries where it is legally enforced, mainly in the countries EEA (European Economic Area). [. . . ]