User manual SONY RXD-700

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Caution -- The use of optical instruments with this product will increase eye hazard. ⷠShould any solid object or liquid fall into the cabinet, unplug the CD Receiver and have it checked by qualified personnel before operating it any further. [. . . ] " " C1 " " B0 " If you store a station at a preset code where you have already stored another station, the previous station is erased. If the mains lead is disconnected for about a month, the preset stations will be cleared from the CD Receiver's memory, and you will have to preset the stations again. This unit stores the station at the preset code you specified. You can listen through the headphones Connect the headphones to the PHONES jack and set SPEAKER A and B to OFF. Press POWER to turn on the CD Receiver and turn VOLUME fully anticlockwise to prevent damaging the speakers with excessive output. You can adjust the volume using the remote Press VOL +/­. Note Avoid high speaker output at which the sound is distorted. Adjust the bass Adjust the treble Adjust the balance Reinforce the bass and treble at low listening level Mute the sound Z If playback doesn`t start from the first track Press PLAY MODE until "SHUFFLE" and "PROGRAM" disappears from the display. You can locate a point quickly by observing the display during pause Press =0/)+ and hold down until you find the point. You will not hear the sound during the operation. Pause during play Resume play after pause Go to the next track Go back to the preceding track Locate a point during play CD ^ (or P on the remote) CD ^ (or P on the remote) )+ (or + on the remote) =0 (or = on the remote) =0 (forward) or )+ (backward) and hold down until you find the point (or 0/) on the remote) 6 OPEN/CLOSE Make sure you have preset radio stations. The display shows only the preset codes where you have stored the stations beforehand. Example: If you have stored the stations onto A1, A3 and C2, the display changes as follows each time you press the PRESET + button. Press ST/MONO to choose the reception mode, select either Auto Stereo or MONO. Press ST/MONO repeatedly until "MONO" disappears from the display. Stations will be received in monaural but with even less noise. You can check information about the CD using the display. You can play tracks repeatedly in any play mode. Checking the total number and playing time of the tracks press DISPLAY before you start playing. The display shows the total number of tracks and total playing time. The information also appears when you press 6 OPEN/CLOSE to close the disc tray. This unit repeats the tracks as follows: When the disc is played in While playing a CD, the display shows the current track number and playing time. [. . . ] /Change speaker positions or room conditions to eliminate obstructions in sound path. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. ⷠDo not use any commercially available stabiliser and/or disc protector. If you do, the CD and this unit may be damaged. [. . . ]