User manual SONY SA-CRW55

[. . . ] The following icons are used in this manual: Indicates that you can use only the remote to do the task. Its design features allow easy connection to your current TV/VCR setup. You can connect this system without having to reconnect the cords of your TV and VCR. also , you don't have to connect a centre speaker to optimize the surround effects. [. . . ] The left and right speakers must be placed standing upright, laying them on their sides will defeat the centre channel surround effect. Turn on a Sony TV operate a Sony TV turn off a Sony TV Spread a towel, or other soft cloth, over a table and lay the speakers down. Peel off the covering sheet from the anti-vibration pad and attach it on the bottom of the speakers (4 for each speaker). Place the rear speakers so that they fire directly across at each other about 60 ­ 90 cm (2 ­ 3 feet) above your listening position. Make sure the anti-vibration pads are securely attached and stand the speaker upright. This section describes how to connect the speaker system and how to connect your TV or VCR to the speakers. Right front speaker Left front speaker VCR To connect, depress the middle of the male connector until it clicks into the female connector. Use the striped wire to connect + to +, and use the solid wire to connect ­ to ­). If the connections are reversed (+ to ­), the sound will be distorted and lack bass. Use the supplied speaker cord to connect the left and right rear speakers. If the audio and video output terminals on your TV and VCR are already connected, and your TV has stereo AUDIO OUT jacks, you can start enjoying surround sound simply by connecting the speaker system to your TV as shown below. Recent movies concerts music sports video game education, news Press SUR OFF on the remote, or press SURROUND on the operation panel a few times until SUR OFF is displayed. Some videos and laser discs may use Dolby Surround sound even if it's not indicated on the package. Although this speaker system is factory preset to provide balanced surround sound without adjustment, you can adjust the volume of each speaker and the delay time to accommodate the conditions in your living room or your individual preference. SUPER WOOFER MODE 1 provides powerful bass sound ideal for movies. The speakers turn on and off automatically (Auto power on/off function) Three minutes after the sound signal goes out (when you turn off the TV, or the currently playing video/ laserdisc ends), the speakers turn off automatically and the POWER indicator turns red. The speakers turn themselves back on the next time you turn on the TV or start playback from the VCR and the POWER indicator turns green. The test tone feature lets you adjust the volume of the sound coming from each speaker to the same level, so that the surround sound will be even and natural. Make the following adjustments from your listening position. If you press POWER on the remote when the speakers are on The speakers enter standby mode (the red standby indicator lights up) and the auto power on/off function will not operate. You have to press POWER on the remote again to turn on the speakers. You can dim the display, or turn it off, according to your preference. [. . . ] ) Press CENTER MODE on the front left speaker a few times until the centre mode you want appears in the display. If you experience any of the following difficulties while using the speakers, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. There's no sound from any of the speakers. [. . . ]