User manual SONY SA-F11

[. . . ] Place the speakers in a location with adequate air circulation, and in a way that does not block the rear ventilation holes. Do not drag the unit along the floor on installment. Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. [. . . ] Press INPUT repeatedly until the DVD indicator lights up. Press MODE repeatedly until the MASTER VOLUME indicator lights up in green, then press and hold LEVEL ­ to set the volume level to minimum. You can adjust the volume selecting the tone level Press MODE repeatedly until the sound level indicator (SW VOL/BASS/TREBLE) you want to change lights up, then press LEVEL + or ­ to adjust the volume of the tone level you select. The table below shows the operations you can do by using the remote. to Turn on/off the power Adjust the volume Select the component Adjust the volume of each tone LFE * Bass S. The tone level indicator of the subwoofer changes automatically when you adjust the volume of each tone using the remote. You can reset the tone level to the factory setting The subwoofer turns on and off automatically according to whether the audio signal is input or not (Auto Power Function) If no audio signal is input for three minutes, the subwoofer switches to standby mode and the 1/u indicator changes to red (Auto Power Off). When an audio signal is input, the subwoofer turn on automatically and the 1/u indicator changes to green (Auto Power On). You can change the woofer mode according to the source press WOOFER MODE on the remote (or press LEVEL + and ­ on the subwoofer at the same time). When the SW VOL indicator on the subwoofer lights up in green, the mode changes to movie mode (factory setting). When the indicator lights up in red, the mode changes to music mode. If you press the 1/u button while listening to the subwoofer, the subwoofer switches to standby mode. Press the 1/u button again to turn it on. If the button is not pressed again within three minutes, the Auto Power On function activates the subwoofer automatically. You can mute the sound You can enjoy virtual 3D sound even without rear speakers when you use the "VES (Virtual Enhanced Surround)" mode in the on-screen menu of the DVPF11. Some Sony DVD players other than the DVP-F11 also have the VES mode option. If you cannot hear the sound from the subwoofer even if you select VES mode, connect your DVD player to the AUX IN jacks of the subwoofer. Refer to the instructions supplied with your DVD player for details. The 5-channel signals of Dolby Digital sound for DVDs are mixed down into 2-channels to be output. Uses 3D sound imaging to create virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers. Uses 3D sound imaging to create virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers. Turn on your TV, DVP-F11, and the subwoofer. [. . . ] Contact between bare speaker wires at the speaker terminals may cause a short-circuit. Design and specifications are subject to change without notice. Andra komponenter som du kan ansluta till det här högtalarsystemet är: ­ DVD-spelare med 5, 1-kanalsutgångar och möjlighet att ange om högtalarna är anslutna till enheten eller ej. Lägg märke till att de kopplingar som beskrivs i bruksanvisningen till DVP-F11 skiljer sig från de som beskrivs i här. [. . . ]