User manual SONY SA-PSD5

[. . . ] Do not subject the glass to extreme changes in temperature. The glass may break because of the extreme changes in temperature. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] Set the wall mounting hooks () on the back of the speakers onto the wall mounting brackets ( or ) (-4). Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system. If the polarity of the speaker connections are not correct, the bass tones will be weak and the position of the various instruments obscure. Contact between bare speaker wires at the speaker terminals may result in a short circuit. Before connecting, turn off the amplifier to avoid damaging the speaker system. If you try to remove it, you may damage the speaker. The volume level should not be turned up to the point of distortion. Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach the screws securely to a beam and fasten them to the wall. Contact a screw shop or installer regarding the wall material or screws to be used. Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength, improper screw installation, or natural calamity, etc. If the sound distorts when you turn on the bass reinforcement from your amplifier (such as, DBFB, GROOVE, the graphic equalizer, etc. Selecting NORMAL or REVERSE with the PHASE selector reverses the polarity and may provide better bass reproduction in certain listening environments (depending on the type of front speakers, the position of the subwoofer and the adjustment of the BASS BOOST). It may also change the expansion and lightness of sound, and affect the feeling of the sound field. Select the setting that provides the sound you prefer when listening in your normal listening position. Each speaker should face the listening position. Better surround effect will result if all speakers are set at the same distance from the listening position. Place the front speakers at a suitable distance to the left and right of the television. place the subwoofer on either side of the television. Place the center speaker in a stable place near the TV set. the placement of surround speakers greatly depends on the configuration of the room. The surround speakers may be placed on both sides of the listening position () or behind the listening position (). [. . . ] Contact between bare speaker wires at the speaker terminals may cause a short circuit. The subwoofer does not automatically turn on when the auto power on/off function is on. Turn the power off, and turn it on again after 10 seconds. If the STANDBY mode continues, unplug the AC power cord and consult your nearest Sony dealer. [. . . ]