User manual SONY SA-VE312 annexe 1

[. . . ] Make sure the program source selector on the amplifier is set to the proper source. There is distortion in the subwoofer sound output. There is hum or noise in the speaker output. Make sure none of the audio components are positioned too close to the TV set. [. . . ] Set the center speaker firmly on the top of or near the TV set, making sure it is completely level. Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. Unplug the system from the wall outlet if it is not to be used for an extended period of time. Should any liquid or solid object fall into the system, unplug the system's power cord and have the system checked by qualified personnel before operating it any further. AC power cord must be changed only at the qualified service shop. For greater flexibility in the positioning of the center, surround and surround back speakers, use the optional WS-FV11 or WS-WV10D speaker stand (available only in certain countries). 1 channel surround sound, join the surround/surround back speakers using the supplied bracket, and attach the supplied speaker stand to the joined speakers. When connecting to an amplifier with internal multi channel decoders (Dolby Digital, DTS*, etc. ), you should use the setup menus for the amplifier to specify the parameters of your speaker system. E, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. While in this mode, if a signal is input to the subwoofer, the subwoofer automatically turns on (auto power on/off function). To turn this feature off, slide the POWER SAVE switch on the rear panel to OFF. Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. Make sure power to all components (included the subwoofer) is turned off before starting the hook-up. If you turn down the volume level of the amplifier too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. Make sure the plus (+) and the minus (­) terminals on the speakers are matched to the corresponding plus (+) and minus (­) terminals on the amplifier. Be sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. [. . . ] Contact between bare speaker wires at the speaker terminals may cause a short circuit. Set the volume level to best suit your preference according to the program source. Rotate BASS BOOST according to the output level that you prefer. Some material is recorded with strong emphasis on bass sounds, which may be accessive in some cases. [. . . ]