User manual SONY SA-VE356T

[. . . ] Should you encounter a problem with your speaker system, check the following list and take the indicated measures. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. To prevent speaker vibration or movement while listening, attach the supplied foot pads to the bottom four corners of the center speaker, front speakers, surround speakers and surround back speaker (D). [. . . ] Speaker system Speaker units Enclosure type Rated impedance Power handling capacity Maximum input power: Sensitivity level Frequency range Dimensions (w/h/d) Mass 2 way, magnetically shielded Woofer: 9 cm Tweeter: 1. Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system. If the polarity of the speaker connections are not correct, the bass tones will be weak and the position of the various instruments obscure. Contact between bare speaker wires at the speaker terminals may result in a short-circuit. Before connecting, turn off the amplifier to avoid damaging the speaker system. If you try to remove it, you may damage the speaker. The volume level should not be turned up to the point of distortion. If you use the amplifier with adjustable crossover frequency, it is recommended to select 150 Hz (or close to this figure) as the crossover frequency for your front, center, and surround speakers. Speaker system Speaker units Enclosure type Rated impedance Power handling capacity Maximum input power: Sensitivity level Frequency range Dimensions (w/h/d) Mass 2 way, magnetically shielded Woofer: 9 cm Tweeter: 1. Listening to the sound (H) First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. This speaker system is magnetically shielded to allow it to be installed near a TV set. However, color irregularities may still be observed on certain types of TV sets. Speaker system Active subwoofer, magnetically shielded Speaker unit Woofer: 15 cm × 2, cone type Enclosure type Acoustically loaded Bass Reflex Reproduction frequency range 28 Hz - 200 Hz Amplifier section Continuous RMS power output 120 W (6 ohms, 100 Hz, 10 % THD) Inputs INPUT (input pin jack) General Power requirements Power consumptions Dimensions (w/h/d) Mass 230 - 240 V AC, 50/60 Hz 120 W 1 W (standby mode) Approx. C Turn off the TV set, then turn it on again after 15 to 30 minutes. C Place the speakers further away from the TV set. [. . . ] Contact between bare speaker wires at the speaker terminals may cause a short-circuit. Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. To enjoy high-quality sound, do not turn the subwoofer volume too high. [. . . ]