User manual SONY SA-VE702

[. . . ] Any difference in operation is clearly indicated in the text, for example, "SA-VE705 only. Make sure power to all components (included the subwoofer) is turned off before starting the hook-up. This configuration is used when the amplifier is connected to a DVD player, LD player, VCR or other video devices. For details, see "Positioning the front (and rear) speakers" on page 7 and "Positioning the center speaker (SA-VE705 only)" on page 8. [. . . ] Using the supplied hex wrench, two screws, and washers, secure the speaker to the stand. Do not remove the supplied speaker grille from the speaker while attaching the speaker to the speaker stand. â· Do not touch or press tweeter's cover on the center of the speaker. Using the supplied hex wrench, two screws, and washers, secure the speaker to the stand. Listening to the sound Do not remove the supplied speaker grille from the speaker while attaching the speaker to the speaker stand. â· Do not touch or press tweeter's cover on the center of the speaker. First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. Power turns on and off automatically -- Auto power on/off function when the subwoofer is on (i. E, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. While in this mode a signal is input to the subwoofer, the subwoofer automatically turns on (auto power on/off function). To turn this feature off, slide the POWER SAVE switch on the rear panel to OFF. For greater flexibility in the positioning of the speakers, use the optional WS-FV10 (floor stand), WS-TV10 (TV stand), or WS-WV10 (wall mount bracket) speaker stand (available only in certain countries). If you turn down the volume level of the subwoofer too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. Slight adjustments to the system can enhance your sound enjoyment. Setting your amplifier to enjoy movies (SA-VE705 only) for the Dolby Digital (AC-3) If your amplifier is connected internally or externally with a Dolby Digital (AC-3) processor, you should use the some setup menus in the amplifier to specify the parameters of your speaker system. See the table below for the proper settings. for details on the setting procedure , refer to the manual that was provided with your amplifier. When "Hookup A" is used (Speaker setup menu) Source DVD, LD, video cassette or other video source MD, CD, cassette tape or other audio source MODE MOVIE MUSIC Set the volume level to suit the program source. Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. [. . . ] â· Make sure the program source selector on the amplifier is set to the proper source. There is distortion in the subwoofer sound output. There is hum or noise in the speaker output. Make sure none of the audio components are positioned too close to the TV set. [. . . ]