User manual SONY SA-VE812ED

[. . . ] The instructions in this manual are for SA-VE815ED and SA-VE812ED, Sony Micro Satellite Systems. 1 channel speaker system consisting of two front speakers, two rear speakers, one center speaker, and one subwoofer. Any difference in operation is clearly indicated in the text, for example, "SA-VE815ED only. Make sure power to all components (included the subwoofer) is turned off before starting the hook-up. [. . . ] Secure the speaker to the stand with the two supplied screws and washers. Do not remove the supplied speaker grille from the speaker while attaching the speaker to the speaker stand. â· Do not touch or press tweeter's cover on the center of the speaker. Secure the center speaker to the stand with the two supplied screws and washers. Listening to the sound Do not remove the supplied speaker grille from the speaker while attaching the speaker to the speaker stand. â· Do not touch or press tweeter's cover on the center of the speaker. First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. Power turns on and off automatically -- Auto power on/off function when the subwoofer is on (i. E, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. While in this mode a signal is input to the subwoofer, the subwoofer automatically turns on (auto power on/off function). To turn this feature off, slide the POWER SAVE switch on the rear panel to OFF. For greater flexibility in the positioning of the speakers, use the optional WS-FV10 (floor stand), WS-TV10 (TV stand), or WS-WV10 (wall mount bracket) speaker stand (available only in certain countries). If you turn down the volume level of the subwoofer too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. Slight adjustments to the system can enhance your sound enjoyment. Setting your amplifier to enjoy movies (SA-VE815ED only) for the Dolby Digital (AC-3) If your amplifier is connected internally or externally with a Dolby Digital (AC-3) processor, you should use the setup menus for the amplifier to specify the parameters of your speaker system. See the table below for the proper settings. for details on the setting procedure , refer to the manual that was provided with your amplifier. When "Hookup A" is used (Speaker setup menu) Source DVD, LD, video cassette or other video source MD, CD, cassette tape or other audio source MODE MOVIE MUSIC Set the volume level to best suit your preference according to the program source. Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. [. . . ] â· Make sure the program source selector on the amplifier is set to the proper source. There is distortion in the subwoofer sound output. There is hum or noise in the speaker output. Make sure none of the audio components are positioned too close to the TV set. [. . . ]