User manual SONY SA-VF700ED

[. . . ] To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. Make sure the plus (+) and the minus (­) terminals on the speakers are matched to the corresponding plus (+) and minus (­) terminals on the amplifier. ⷠBe sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. ⷠMake sure all connections are firm. [. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. This Class B digital apparatus complies with Canadian ICES-003. As ENERGY STAR® Partner, Sony Corporation has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. Each speaker should face the listening position. better Surround effect will result if all speakers are set at the same distance from the listening position. Place the front speakers at an equal distance to the left and right of the television. You can adjust the sound of the subwoofer to suit the sound of your front speakers. Reinforcing the bass sound gives you a greater sense of atmosphere. POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 3 ohms loads both subwoofer driven, from 20 - 200 Hz; rated 250 watts minimum RMS power, with no more than 0. Turn the SW LEVEL so that you can hear the bass sound a little more than before. To increase the subwoofer level, turn the control clockwise. To decrease the subwoofer level, turn the control counterclockwise. Connect the AC power cord from the front speaker (subwoofer) and from your amplifier to a wall outlet. [. . . ] Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If you turn down the volume level of the amplifier too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. There is no sound from the speaker system. Make sure the volume on the amplifier has been turned up properly. [. . . ]