User manual SONY SA-VS200H

[. . . ] 1 channel speaker system consisting of two front speakers, two surround speakers, one center speaker, and one subwoofer. Set the center speaker firmly on the top of or near the TV set, making sure it is completely level. There is no sound from the speaker system. [. . . ] Contact between bare speaker wires at the speaker terminals may result in a short circuit. Before connecting, turn off the amplifier to avoid damaging the speaker system. If you try to remove it, you may damage the speaker. The volume level should not be turned up to the point of distortion. If you use the amplifier with adjustable crossover frequency, it is recommended to select 150 Hz (or close to this figure) as the crossover frequency for your front, center, and surround speakers. Listening to the sound (E) First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. This speaker system is magnetically shielded to allow it to be installed near a TV set. However, color irregularities may still be observed on certain types of TV sets. C Turn off the TV set, then turn it on again in 15 to 30 minutes. C Place the speakers further away from the TV set. Power turns on and off automatically -- Auto power on/off function (F) if the subwoofer is on (i. E, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. While in this mode, if a signal is input to the subwoofer, the subwoofer automatically turns on (auto power on/off function). [. . . ] Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. To enjoy high-quality sound, do not turn the subwoofer volume too high. If the sound distorts when you turn on the bass reinforcement from your amplifier (such as, DBFB, GROOVE, the graphic equalizer, etc. [. . . ]