User manual SONY SA-VS350H annexe 2

[. . . ] The picture is one example of how to connect the speakers to an amplifier. For details regarding the connections of an amplifier, refer to the operating instructions that were provided with your amplifier. Make sure the plus (+) and the minus (­) terminals on the speakers are matched to the corresponding plus (+) and minus (­) terminals on the amplifier. [. . . ] ⷠAC power cord must be changed only at the qualified service shop. Speaker system Speaker units Enclosure type Reproduction frequency range 28 Hz - 200 Hz Continuous RMS power output 150 W (6 ohms 100 Hz, 10% THD) Input LINE IN (input pin jack) General Power requirements Power consumptions Dimensions (w/h/d) Mass 220 - 230 V AC, 50/60 Hz 90 W/less than 0. Lights up green when the subwoofer is on. Lights up red when the subwoofer is in power saving mode. To enjoy high-quality sound, do not turn the subwoofer volume too high. Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system. ⷠIf the polarity of the speaker connections are not correct, the bass tones will be weak and the position of the various instruments obscure. ⷠBefore connecting, turn off the amplifier to avoid damaging the speaker system. If you try to remove it, you may damage the speaker. ⷠThe volume level should not be turned up to the point of distortion. Switching the phase polarity may provide better bass reproduction in certain listening environments (depending on the type of front speakers, the position of the subwoofer and the adjustment of the BASS BOOST). Select the setting that provides the sound you prefer when listening in your normal listening position. Design and specifications are subject to change without notice. If the subwoofer is on and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. Do not place the speakers in locations that are: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Subject to vibrations -- Subject to direct sunlight · Use caution when placing the speaker on a specially treated (waxed, oiled, polished, etc. ) floor, as staining or discoloration may result. [. . . ] ⷠSome material is recorded with strong emphasis on bass sounds, which may be excessive in some cases. If this happens, rotate BASS BOOST towards minimum. Each speaker should face the listening position. [. . . ]