User manual SONY SAL-70200G

[. . . ] If dirt, etc. , gets on the lens contacts, it may interfere or prevent the sending and receiving of signals between the lens and the camera, resulting in operational malfunction. Condensation If your lens is brought directly from a cold place to a warm place, condensation may appear on the lens. To avoid this, place the lens in a plastic bag or something similar. [. . . ] Align a gray index on the tripod-mounting collar with the gray index (collar index) on the lens to adjust the camera position precisely (2). · Tighten the collar-locking knob firmly after the camera position is set. (1) (2) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ­ Consult the dealer or an experienced radio/TV technician for help. To detach the tripod-mounting collar The tripod-mounting collar can be detached. (3) (4) 1 2 3 4 Remove the lens from the camera. · See " Attaching/detaching the lens" for details. Loosen the collar-locking knob (1). Rotate the tripod-mounting collar to align the red index on the tripodmounting collar (collar mounting index next to SET/RELEASE) with the orange index on the lens (mounting index) (3). Move the tripod-mounting collar towards the lens mount and detach the tripod-mounting collar from the lens (4). For the customers in Canada This Class B digital apparatus complies with Canadian ICES-003. Notes on use · Do not leave the lens in direct sunlight. If sunlight is focused onto a nearby object, it may cause a fire. If circumstances necessitate leaving the lens in direct sunlight, be sure to attach the lens cap. · Be careful not to subject the lens to mechanical shock while attaching it. [. . . ] · This lens is equipped with a distance encoder. The distance encoder allows more accurate measurement (ADI) by using a flash for ADI. [. . . ]