User manual SONY SA-L16F28

[. . . ] · Be careful not to subject the lens to mechanical shock while attaching it. · Always place the lens caps on the lens when storing. · Do not keep the lens in a very humid place for a long period of time to prevent mold. [. . . ] The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. 1 Remove the rear and front lens caps and the camera body cap. 2 Align the orange index on the lens barrel with the orange index on the camera (mounting index), then insert the lens into the camera mount and rotate it clockwise until it locks. · Do not press the lens release button on the camera when mounting the lens. · Do not mount the lens at an angle. To remove the lens While pressing and holding the lens release button on the camera, rotate the lens counterclockwise until it stops, then detach the lens. To attach the front lens cap Attach the front lens cap fully, and pull the string. For the customers in the U. S. A. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. 2 1 Focusing When using the auto focus, the camera focuses the lens automatically. When focusing manually, set your camera to the manual focus and rotate the focusing ring while looking through the viewfinder. The focus signal in the viewfinder indicates the current condition of the focus. CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ­ Consult the dealer or an experienced radio/TV technician for help. Note This lens is a wide angle type. Make sure the shoulder-strap, your fingers, etc. , are not in the frame when a picture is taken. Depth-of-field scale When focus is set on a subject, anything at that same distance will appear sharp, and anything within a certain range before and beyond the subject will also appear in focus; this is called depth of field. [. . . ] 400 (14 1/8) *1 The value for equivalent 35mm-format focal length is based on Digital Single Lens Reflex Cameras equipped with an APS-C sized image sensor. *2 The value of angle of view 1 is based on 35mm-format cameras, and that of angle of view 2 is based on Digital Single Lens Reflex Cameras equipped with an APS-C sized image sensor. *3 Minimum focus is the shortest distance from the image sensor to the subject. Depending on the lens mechanism, the focal length may change with any change of the shooting distance. [. . . ]