User manual SONY SAL18200

[. . . ] ⷠDo not use any organic solvent, such as thinner or benzine, to clean the lens or the camera cone. When focusing manually, set your camera to the manual focus and rotate the focusing ring while looking through the viewfinder. Do not rotate the focusing ring all the way to the end when focusing manually, even at infinity. [. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 6: Fit the hood into the mount on the end of the lens barrel and rotate the hood clockwise until it clicks. Turn the hood clockwise until the red line on the lens meets the red dot on the hood and it clicks into place. ⷠWhen using a built-in camera flash, make sure to remove the lens hood to avoid blockage of the flash light. Otherwise, the lens hood may interfere with the desired effect or may appear in pictures. ⷠWhen storing, turn over the lens hood and place it onto the lens backwards. This Class B digital apparatus complies with Canadian ICES-003. If sunlight is focused onto a nearby object, it may cause a fire. If circumstances necessitate leaving the lens in direct sunlight, be sure to attach the lens cap. ⷠBe careful not to subject the lens to mechanical shock while attaching it. [. . . ] ⷠDepending on the lens mechanism, the focal length may change with any change of the shooting distance. If your lens is brought directly from a cold place to a warm place, condensation may appear on the lens. To avoid this, place the lens in a plastic bag or something similar. [. . . ]