User manual SONY SAL50M28

[. . . ] Remove the rear and front lens caps and the camera body cap. â· You can attach/detach the front lens cap in two ways, (1) and (2). When you attach/detach the lens cap with the lens hood attached, use method (2). [. . . ] While the focus-hold button is pressed, auto focus function is suspended and the focus is fixed for shooting. â· The function of the focus-hold button can be changed on cameras with custom function capability. For quick focusing, the focusing range can be limited to close or far range, depending on the distance to your subject. This Class B digital apparatus complies with Canadian ICES-003. If sunlight is focused onto a nearby object, it may cause a fire. If circumstances necessitate leaving the lens in direct sunlight, be sure to attach the lens cap. â· Be careful not to subject the lens to mechanical shock while attaching it. â· Always place the lens caps on the lens when storing. â· Do not keep the lens in a very humid place for a long period of time to prevent mold. â· After attaching the lens, do not carry the camera by holding the lens. , gets on the lens contacts, it may interfere or prevent the sending and receiving of signals between the lens and the camera, resulting in operational malfunction. To focus on subjects at close range (see the table above), set focus anywhere near the subject and then set the focus-range limiter to LIMIT; the focusing range is limited to Close-focusing range. Likewise, when shooting subjects at far range, set the focus anywhere near the subject and then set the focusrange limiter to LIMIT; the focus range is limited to Far-focusing range. Set the focus-range limiter to FULL to allow the entire focusing range. [. . . ] If your camera is set to the manual exposure mode and you are using a hand-held exposure meter, or if your camera is set to the manual exposure mode and you are using the Manual Flash Control function available on some external flash units, refer to the exposure compensation table , and adjust exposure accordingly. , when adjusting by the aperture, +2 means opening the aperture 2 more stops. 5 Lens groupselements 6-7 8-8 8-10 Angle of view 1*2 Angle of view 2*2 Minimum focus*3 (m (feet)) 0. [. . . ]