User manual SONY SAVA-700

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. AC power cord must be changed only at the qualified service shop. ⷠBefore operating the speakers, check that the operating voltage is identical with your local power supply. [. . . ] With its built-in amplifier, this speaker system can be used to output sound directly from such components as CD players, DVD (2-channel) players, LD players, and VCRs. The combined amplification from the component and the speaker's built-in amplifier may damage the speakers. * It is possible to use a pair of audio cords instead of two monaural audio cords to connect to the 5. Front speaker size center speaker size rear speaker size subwoofer selection To obtain high sound quality and a proper sound image from the front speakers, place the speaker with the built-in operation panel to the left of your TV and the other to the right of your TV. For the best sound image, place the left and right speakers within 8 ft (2. 5 m) of each other and equidistant from the TV. To enjoy theater-quality Multi-Channel Surround sound Place the rear speakers so that they face directly across from each other about 2 to 3 ft (60 to 90 cm) above the listener's ear. For optimum sound, face each rear speaker as directly towards the center speaker as possible. Positioning the center and rear speakers for better surround sound effect (SAVA-700 only) For better surround sound quality, position each speaker as shown below. Each rear speaker should be placed as its tweeter is on the inner side. the grille can be detached to visually verify the orientation. The "SONY" plaque on each satellite speakers can be rotated to match the speaker's orientation. Before disconnecting the left front speaker's AC power cord, turn the system off first. If you press 1/u on the remote while the system is on You can dim the display or turn it off. Press DIMMER on the remote repeatedly until your favorite brightness of the display comes up. 3 Adjust the volume level to around 15 with MASTER VOL +/­. Check that the test tone is output from each speaker in following order: / Front (Left) / Center / Front (Right) Rear (Left) ?Press U on the lower part of the left front speaker. The ON indicator on the left front speaker lights up. When the speaker system is in standby or ready mode (i. , the STANDBY or READY indicator on the left front speaker lights up), press INPUT (or either 1/u or INPUT SELECT on the remote). When you press U, the ON indicator goes off and the speaker system is totally deactivated. [. . . ] Accepts only supplied SS-CN16 Rear speaker Accepts only supplied SS-SR16 Wireless rear speaker Accepts only Sony models R-ch speaker Accepts only SAVA-500 R-ch speaker with supplied exclusive speaker cord Bass: ±10 dB at 100 Hz Treble: ±10 dB at 10 kHz These jacks are used to input decoded multichannel format audio signals (e. Use these jacks to connect a multi-channel decoder or a DVD player with a built-in multi-channel decoder. Select one of the following four center modes according to your speaker system. Select PHANTOM mode if you do not want to use the center speaker to output sound. [. . . ]