User manual SONY SA-VA35

[. . . ] There is distortion in the subwoofer sound output. There is hum or noise in the speaker output. Make sure none of the audio components are positioned too close to the TV set. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. [. . . ] The instructions in this manual are for SA-VA35, Sony Micro Satellite Systems. 1 channel speaker system consisting of two front speakers, two surround speakers, one center speaker, and one subwoofer. To prevent speaker vibration or movement while listening, attach the supplied foot pads to the bottom four corners of the center speaker, front speakers, and surround speakers. For greater flexibility in the positioning of the speakers, use the optional WS-FV10D or WS-WV10D speaker stand (available only in certain countries). Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. ⷠThe unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. ⷠUnplug the system from the wall outlet if it is not to be used for an extended period of time. Should any liquid or solid object fall into the system, unplug the system's power cord and have the system checked by qualified personnel before operating it any further. ⷠAC power cord must be changed only at the qualified service shop. Speaker unit Enclosure type Amplifire section Continuous RMS power output 100 W (6 ohms, 20 - 250 Hz, 0. Do not place the speakers in locations that are: --Extremely hot or cold --Dusty or dirty --Very humid --Subject to vibrations --Subject to direct sunlight · Use caution when placing the speaker on a specially treated (wax, oiled, polished, etc. ) floor, as staining or discoloration may result. Set the volume level to best suit your preference according to the program source. Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. To enjoy high-quality sound, do not turn the subwoofer volume too high. Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. 5 m (3) Design and specifications are subject to change without notice. [. . . ] 5 m (3) Design and specifications are subject to change without notice. The volume level should not be turned up to the point of distortion. If the volume level is too high, the speaker protection circuit activates, and the sound level drops suddenly. In this case, lower the volume level and wait for a few moments until the unit resumes normal operation. [. . . ]