User manual SONY SA-VA59

[. . . ] ⷠMake sure the program source selector on the amplifier is set to the proper source. There is distortion in the subwoofer sound output. There is hum or noise in the speaker output. Make sure none of the audio components are positioned too close to the TV set. [. . . ] Make sure none of the audio components are positioned too close to the TV set. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. 1 channel speaker system consisting of two front speakers, two surround speakers, one center speaker, and one subwoofer. Set the center speaker firmly on top of the TV set, making sure it is completely level. For greater flexibility in the positioning of the speakers, use the optional WS-FV10D or WS-WV10D speaker stand (available only in certain countries). The height of the front speakers should be adjusted to about the center of the TV screen (G). Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. ⷠThe unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. ⷠUnplug the system from the wall outlet if it is not to be used for an extended period of time. Should any liquid or solid object fall into the system, unplug the system's power cord and have the system checked by qualified personnel before operating it any further. E, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. While in this mode a signal is input to the subwoofer, the subwoofer automatically turns on (auto power on/off function). To turn this feature off, slide the POWER SAVE switch on the rear panel to OFF. Do not place the speakers in locations that are: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Subject to vibrations -- Subject to direct sunlight · Use caution when placing the speaker on a specially treated (waxed, oiled, polished, etc. ) floor, as staining or discoloration may result. If you turn down the volume level of the amplifier too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. 5 m (3) Design and specifications are subject to change without notice. Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. [. . . ] Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. Source DVD, LD, video cassette or other video source MD, CD, cassette tape or other audio source MODE MOVIE MUSIC (A) Make sure power to all components (included the subwoofer) is turned off before starting the hook-up. Set the volume level to best suit your preference according to the program source. [. . . ]