User manual SONY SA-VE11P

[. . . ] It supports Sony Digital Cinema Sound, Dolby* Pro Logic, and Dolby Digital (AC-3), and is thus geared towards the enjoyment of movies. * Manufactured under license from Dolby Laboratories. DOLBY, the double-D symbol ;, "PRO LOGIC" and "Dolby Digital (AC-3)" are trademarks of Dolby Laboratories. Front (Right) Ee Subwoofer Ee Center Front (Left) Ee Owner's Record The model and serial numbers are located on the rear of the unit. [. . . ] · Do not place the speakers in locations that are: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Subject to vibrations -- Subject to direct sunlight Tip All black wires are minus (­) in polarity, and should be connected to the minus (­) speaker terminals. Connecting to an amplifier with a special jack for a subwoofer If your amplifier has a special jack for a subwoofer (like a SUBWOOFER jack, MIX OUT jack, MONO OUT jack or SUPER WOOFER jack), connect the LINE IN jack of the woofer to one of those jacks. On cleaning Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. CAUTION You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. Hookups Amplifier SUBWOOFER OUT This woofer LINE IN Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Connect the SUBWOOFER jack of your amplifier to the LINE IN jack of the subwoofer with the supplied audio connecting cord. 2001 Sony Corporation Printed in Malaysia Setting the center speaker Listening to the sound Foot pads LEVEL POWER MIN MAX Adjusting the subwoofer (SA-WMSP1) Troubleshooting Should you encounter a problem with your speaker system, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 8 ohm loads, from 28 - 200 Hz; rated 50 watts per channel minimum RMS power, with no more than 0. 8% total harmonic distortion from 250 milliwatts to rated output. LEVEL Micro Satellite System POWER (?/1) POWER indicator MIN MAX For Speakers There is no sound from the speaker system. ·Make sure all the connections have been correctly made. ·Make sure the volume on the amplifier has been turned up properly. ·Make sure the program source selector on the amplifier is set to the proper source. ·Check if headphones are connected. There is distortion in the subwoofer sound output. ·Check if any sound-enhancing functions have been activated on the amplifier. There is hum or noise in the speaker output. ·Make sure all the connections have been correctly made. ·Make sure none of the audio components are positioned too close to the TV set. ·Make sure all the connections have been correctly made. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. For Subwoofer (SA-WMSP1) There's no sound. [. . . ] The rear speakers may be placed on both sides of the listening position A or behind the listening position B. · Always install the woofer vertically, keeping a few centimeters from away the wall. · Do not place an object on the woofer or sit on it. · If the woofer is installed in the center of a room, the bass could be extremely weakened. [. . . ]