User manual SONY SA-VE230

[. . . ] 6 Listening to the sound . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Adjusting the sound . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press POWER on the subwoofer. The POWER indicator on the subwoofer lights up in green. LEVEL MODE 1 Set MODE according to the program source as follows: Source DVD, LD, video cassette, or other video source MD, CD, cassette tape, or other audio source MODE MOVIE MUSIC Play the program source. 2 Rotate LEVEL to adjust the volume. Set the volume level to best suit your preference according to the program source. Notes · Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. If such distortion occurs, turn off those functions. · To enjoy high-quality sound, do not turn the subwoofer volume too high. · The bass sound is enhanced in MOVIE mode rather than in MUSIC mode. Therefore, if you change the mode to MOVIE while listening to some sources that do not include the bass sound, you may not be able to get the effect. 7 Setting your amplifier to enjoy movies For the Dolby Digital (AC-3) If your amplifier is connected internally or externally with a Dolby Digital (AC-3) processor, you should use the setup menus for the amplifier to specify the parameters of your speaker system. See the table below for the proper settings. For details on the setting procedure, refer to the manual that was provided with your amplifier. Speaker setup For Front speakers Center speaker Rear speakers Subwoofer Set to SMALL SMALL SMALL ON (or YES) Precautions On safety · Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. · The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. · Unplug the system from the wall outlet if it is not to be used for an extended period of time. To disconnect the cord, pull the cord by grasping the plug. · Should any liquid or solid object fall into the system, unplug the system's power cord and have the system checked by qualified personnel before operating it any further. · AC power cord must be changed only at the qualified service shop. On operation · Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system. · If the polarity of the speaker connections are not correct, the bass tones will be weak and the position of the various instruments obscure. · Contact between bare speaker wires at the speaker terminals may result in a short-circuit. · Before connecting, turn off the amplifier to avoid damaging the speaker system. [. . . ] Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. 9 Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 6 ohm loads both channels driven, from 20 - 150 Hz; rated 50 watts per channel minimum RMS power, with no more than 0. 8% total harmonic distortion from 250 milliwatts to rated output. SS-V230 Front and rear speakers Speaker system Speaker units Enclosure type Rated impedance Power handling capacity Maximum input power: Sensitivity level Frequency range Dimensions (w/h/d) Mass Full range, magnetically shielded 5 × 9 cm (2 × 3 5/8 in. ), cone type Bass reflex 8 ohms 100 watts 86 dB (1 W, 1 m) 90 Hz - 20, 000 Hz Approx. [. . . ]