User manual SONY SA-W11

[. . . ] The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Do not connect either wire to the earth terminal in the plug which is marked by the letter E or by the safety earth symbol Y or coloured green or green-and-yellow. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The model number and serial numbers are located at the rear. [. . . ] ⷠUse the audio connecting cords that are supplied to the respective equipment. If there are not enough audio connecting cords to make the necessary connections, you need to purchase some optional audio connecting cords. ⷠBe sure to make connections firmly to avoid noise. ⷠConnect the AC power cord from the woofer to a wall outlet. ⷠYou cannot connect the CENTER output jack for use with Dolby Pro Logic function to the woofer. Bass sound is not output with some Dolby Pro Logic modes. Connecting to an amplifier with a single set of speaker terminals If your amplifier is equipped with a single set of speaker terminals, connect the woofer to the amplifier, and then connect the front speakers to the woofer. If your amplifier has double(A+B) sets of speaker terminals, connect both the woofer and the front speakers to the amplifier. Twist the stripped ends of the cord about 2/3 inch (15 mm). be sure to match the speaker cord to the appropriate terminal on the componentes: + to + and ­ to ­. If the cords are reversed, the sound will be distorted and will lack bass. Reinforcing the bass sound gives you a greater sense of atmosphere. If the sound distorts when you turn on the bass reinforcement from your amplifier (such as, DBFB, GROOVE, the graphic equalizer, etc. Turn the CUT OFF FREQ control, depending on the reproduction 100Hz frequencies of your front speakers. 50Hz 4 Typical large sized speakers: more than 25 cm dia. Selecting NORMAL or REVERSE with the PHASE selector reverses the polarity and may provide better bass reproduction in certain listening environments (depending on the type of front speakers, the position of the woofer and the adjustment of the cut-off frequency). It may also change the expanse and tightness of sound, and effect the feeling of the sound field. Select the setting that provides the sound you prefer when listening in your normal listening position. To make the most of the low level converter function of Dolby digital, turn the CUT OFF FREQ as high as possible when playing back the Dolby digital (AC-3). Turn the LEVEL control so that you can hear the bass sound a little more than before. select MOVIE or MUSIC with MODE selector. Male vocal tunes and voice containing bass sounds are most suitable for adjustment. [. . . ] With the magnetically shielded type of the speaker system, the speakers can be installed near a TV set. However, color irregularity may still be observed on the TV screen depending on the type of your TV set. NTurn off the TV set once, then turn it on after 15 to 30 minutes. NPlace the speakers further apart from the TV set. [. . . ]