User manual SONY SCD-XE597 annexe 1

[. . . ] To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To prevent fire, do not cover the ventilation of the apparatus with news papers, table-cloths, curtains, etc. and don't place lighted candles on the apparatus. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. [. . . ] The player will stop after playing all the tracks once. The player does not go back to tracks which have already been played. If you turn off the player or disconnect the power cord, Repeat Play is canceled. Repeat Play stops automatically after all the tracks have been repeated five times. You can pick out the tracks that you like and specify the playback order in a program containing up to 32 steps (or 999 min. Before you start playing or while the player is playing, press CHECK on the remote repeatedly. If you entered the wrong track number Each time you press the button, the track numbers will appear in the display in the programed order. If you press CHECK on the remote while the player is playing, the programed track numbers will appear starting with the currently playing program step. Repeatedly until the track number you want to erase appears. Then repeat Steps 2 and 3 to enter the correct track number. Repeat Steps 2 through 3 to enter other tracks. Each time you enter a track number, the total number of program steps appears in the display. Erase from the last track in the program Each time you press the button, the last track of the program is erased. The front speaker setting is set to "L" automatically when you set the sub woofer to "­­". When you play a track that does not contain the LFE* signal, the signal for the sub woofer does not output. Therefore, when you select "Mch DIRECT", "5­ LARGE+SW", or "NO­CNTR+SW", no signal outputs from the sub woofer. However, when you select "5­SMALL+SW" or "F­LARGE+SW" (when you set the speaker setting to "S"), the bass frequencies will come from the sub woofer. If you select a playback mode other than "2ch DIRECT" or "Mch DIRECT" using the Multichannel management function, the sound distribution to the speakers will change, possibly causing a decrease in overall sound volume. If this occurs, adjust the volume with the volume control on the connected amplifier. If you change the playback mode while the player is in Multi-channel mode, the output level balance settings will be canceled. This function cannot be used during CD playback. Some adjustment may not work depending on the Multi-channel mode that you selected. [. . . ] When you play a track that does not contain the LFE signal, the signal outputs from the SUB WOOFER jack only when you select "5­ SMALL+SW" or "F­LARGE+SW" for Multichannel mode (page 15). A disc cannot be ejected and "LOCKED" appears in the front panel display. If the player still does not operate properly, or if other problems not described above occur, turn off the player, unplug it from the power outlet for a few minutes, then reinsert the plug into the power outlet. When a Super Audio CD is played Playing frequency range 2 Hz to 100 kHz Frequency response 2 Hz to 40 kHz (­3 dB) Dynamic range 100 dB or more Total harmonic distortion rate 0. [. . . ]