User manual SONY SDM-E96D

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Also, if necessary, you can fine tune the color temperature. If the picture is not in the center of the screen, adjust the picture's centering as follows. Whites will change from a bluish hue to reddish hue as the temperature is lowered from 9300K (default setting) to 6500K. When using the SDM-X52 model, it is not necessary to set the resolution. Since this adjustment changes the color temperature by increasing or decreasing the R and B components with respect to G (green), the G component is fixed. The new color setting is stored in memory for USER ADJUSTMENT and automatically recalled whenever USER is selected. You can associate the picture's color shade on the screen with the picture's original color shade. If the picture displayed at the FULL2 or FULL1 mode of ZOOM is not smooth, use the picture smoothing function. GRAPHICS: To make the pictures appear clean. When you set the (ZOOM) menu to REAL, the (SMOOTHING) menu is not available. 1024 × 768 (SDM-X52), 1280 × 1024 (SDM-E96D/X82) resolution signals are shown only in REAL mode and SMOOTHING is not possible. If there is something wrong with the input signal, one of the following messages appears on the screen. This indicates that the input signal is not supported by the monitor's specifications. Check the following items For more information about on-screen messages, see "Trouble symptoms and remedies" on page 20 (POWER SAVE) is set to "ON, " the monitor will enter the power saving mode after about 5 seconds from the time the message is displayed. X kHz/xxx Hz" is displayed This indicates that either the horizontal or vertical frequency is not supported by the monitor's specifications. This indicates that no signal is being input via the currently selected connector. (POWER SAVE) is set to "ON, " the monitor will enter the power saving mode after about 5 seconds from the time the message is displayed. Use the self-diagnosis function (page 22) if the following recommendations do not resolve the problem. Symptom No picture If the 1 (power) indicator is not lit, or if the 1 (power) indicator will not light up when the 1 (power) switch is pressed, If the 1 (power) indicator is green, If CABLE DISCONNECTED appears on the screen, · Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (page 7). If you connect a non-supplied video signal cable, CABLE DISCONNECTED may appear on the screen before entering the power saving mode. Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (page 7). XProblem caused by a connected computer or other equipment, and not caused by the monitor · the computer is in the power saving mode. [. . . ] These are related to another group of environmental toxins, PCBs, which are suspected to give rise to similar harm, including reproductive damage in fisheating birds and mammals, due to the bioaccumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. TCO'95 demand requires that plastic components weighing more than 25 grams must not contain organically bound chlorine and bromine. Your choice has provided you with a product developed for professional use. [. . . ]