User manual SONY SDM-G206W

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Press the MENU button once to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds. You can reset the adjustments using the RESET menu. The menu automatically disappears about 5 seconds after adjusting brightness. For more information about adjusting the backlight see "Adjusting the backlight" on page 14. Note You can adjust neither contrast nor brightness when displaying the main menu on the screen. When the monitor receives an input signal, the automatic picture quality adjustment function of this monitor automatically adjusts the picture position, phase, and pitch, and ensures that a clear picture appears on the screen. For more information about this function, see "Automatic picture quality adjustment function" on page 16. For some input signals, this function may not completely adjust the picture position, phase, and pitch. In this case, you can manually set these adjustments according the following instructions. If you manually set these adjustments, they are stored in memory and automatically recalled whenever the monitor receives the same input signals. If any other items are selected, the mark appears on the screen. To cancel the menu lock Repeat the procedure above and set and If the monitor is connected to a computer or video graphics board that is DPMS (Display Power Management Signaling) compliant, the monitor will automatically reduce power consumption as shown below. When the monitor receives an input signal, it automatically matches the signal to one of the factory preset modes stored in the monitor's memory to provide a high quality picture at the center of the screen. For input signals that do not match one of the factory preset modes, the automatic picture quality adjustment function of this monitor automatically adjusts the picture position, phase, and pitch, and ensures that a clear picture appears on the screen for any timing within the monitor's frequency range (horizontal: 28 ­ 61 kHz (SDM-G206W), 28 ­ 80 kHz (SDM-S71R/S81R), vertical: 48 ­ 75 Hz). If you connect a non-supplied video signal cable, CABLE DISCONNECTED may appear on the screen before entering the power saving mode. Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (page 7). Try pressing any key on the keyboard or moving the mouse. Check that your graphic board is attached to the computer properly. If you replaced an old monitor with this monitor, reconnect the old monitor and adjust the frequency range to the following: Horizontal: 28 ­ 61 kHz (SDM-G206W), 28 ­ 80 kHz (SDM-S71R/S81R) Vertical: 48 ­ 75 Hz · If you replaced an old monitor with this monitor, reconnect the old monitor and do the following. Select "SONY" from the "Manufactures" list and select "SDM-G206W" or "SDM-S71R"or "SDM-S81R" from the "Models" list in the Windows device selection screen. If "SDM-G206W" or "SDM-S71R"or "SDM-S81R" does not appear in the "Models" list, try "Plug & Play". [. . . ] These are related to another group of environmental toxins, PCBs, which are suspected to give rise to similar harm, including reproductive damage in fisheating birds and mammals, due to the bioaccumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. TCO'95 demand requires that plastic components weighing more than 25 grams must not contain organically bound chlorine and bromine. Your choice has provided you with a product developed for professional use. [. . . ]