User manual SONY SDM-G76D

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Press the M/m buttons to make the adjustment, then press the OK button. When you press the OK button, the setting is stored, then the display returns to the previous menu. Press the MENU button once to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 45 seconds. You can reset the adjustments using the RESET menu. For more information about resetting the adjustments, see "0 (RESET)" on page 16. If the screen is too bright, adjust the backlight and make the screen easier to see. Note The backlight cannot be adjusted when the ECO mode is set to "ON" (page 17). When the monitor receives an input signal, it automatically adjusts the picture's position and sharpness (phase/pitch), and ensures that a clear picture appears on the screen (page 17). Note While the automatic picture quality adjustment function is activated, only the 1 (power) switch will operate. If the automatic picture quality adjustment function of this monitor seems to not completely adjust the picture By pressing the AUTO button, you can make further automatic adjustment of the picture quality for the current input signal (page 5). Sub-1280 × 1024 signals are displayed at the center of the screen surrounded by a black frame. Note When you use 1280 × 1024 resolution signals, the above mentioned settings are not available. The following menus appear on the screen when you keep pressing the m button. Keep pressing the m button until the desired menu's item you want to adjust appears on the screen. press the M/m buttons to select the desired menu and press the OK button. Adjust the selected menu according to the following instructions. Note that the (LANGUAGE) setting is not reset by this method. You can choose one of 9 positions where the menu will appear. If you attempt any other operation, the (MENU LOCK) appears on the screen. If you set the (MENU LOCK) to ON, only this menu item can be selected. ON: Enters the power saving mode automatically when no input signal is being input via currently selected computer. [. . . ] Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. The relevant TCO'99 demand requires that plastic components weighing more than 25 grams must not contain flame retardants with organically bound bromine or chlorine. Flame retardants are allowed in the printed circuit boards since no substitutes are available. Your choice has provided you with a product developed for professional use. [. . . ]