User manual SONY SDM-HS53

[. . . ] After a while, the window of the CD-ROM will open automatically. Note Depending on a computer you are using, the window of the CD-ROM may not open automatically. [. . . ] If necessary, use an adapter (not supplied). Turn on your monitor first, then a computer. 4 Connect the power cord to a power outlet. 1 Back cover lights in green The illustration of the back of the monitor show here is that of the SDM-HS53. Trouble symptoms and remedies (If no picture appears on the screen) If no picture appears on the screen, check the following table for possible solutions. Then, if the problem persists, use the self-diagnosis function (page 5 (US)). If you are experiencing difficulties not listed below, refer to the Operating Instructions on the supplied CD-ROM. For problems caused by a computer or other equipment, refer to the user's manuals supplied with the respective items. Symptom If the 1 (power) indicator is not lit, or if the 1 (power) indicator will not light up when the 1 (power) switch is pressed, If the 1 (power) indicator is green or flashing orange, If CABLE DISCONNECTED appears on the screen, Check these items · Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (page 2 (US)). If you connect a non-supplied video signal cable, CABLE DISCONNECTED may appear on the screen before entering the power saving mode. Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (page 2 (US)). X Problems caused by a computer or other equipment connected, and not caused by the monitor · the computer is in the power saving mode. [. . . ] Horizontal sync width duty should be more than 4. Horizontal blanking width should be more than 2. [. . . ]