User manual SONY SDM-HS74P

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] ) If you still need to make further adjustments to the picture quality You can manually adjust the picture's sharpness (phase/pitch) and position (horizontal/vertical position). These adjustments are stored in memory and automatically recalled when the display receives the same input signal. X Make further automatic adjustments to the picture quality for the current input signal (AUTO) If vertical stripes are observed over the entire screen, adjust pitch by the following steps. You can select the picture's color level of the white color field from the default color temperature settings. Also, if necessary, you can fine tune the color temperature. If the picture is not in the center of the screen, adjust the picture's centering as follows. Whites will change from a bluish hue to reddish hue as the temperature is lowered from 9300K (default setting) to 6500K. When using the SDM-X52 model, it is not necessary to set the resolution. Since this adjustment changes the color temperature by increasing or decreasing the R and B components with respect to G (green), the G component is fixed. The new color setting is stored in memory for USER ADJUSTMENT and automatically recalled whenever USER is selected. You can associate the picture's color shade on the screen with the picture's original color shade. If you manually set these adjustments, they are stored in memory as user modes and automatically recalled whenever the monitor receives the same input signals. Before contacting technical support, refer to this section. This indicates that the video signal cable has been disconnected from the currently selected connector. If there is something wrong with the input signal, one of the following messages appears on the screen. This indicates that the input signal is not supported by the monitor's specifications. For more information about on-screen messages, see "Trouble symptoms and remedies" on page 20 (POWER SAVE) is set to "ON, " the monitor will enter the power saving mode after about 5 seconds from the time the message is displayed. X kHz/xxx Hz" is displayed This indicates that either the horizontal or vertical frequency is not supported by the monitor's specifications. This indicates that no signal is being input via the currently selected connector. (POWER SAVE) is set to "ON, " the monitor will enter the power saving mode after about 5 seconds from the time the message is displayed. Use the self-diagnosis function (page 22) if the following recommendations do not resolve the problem. Symptom No picture If the 1 (power) indicator is not lit, or if the 1 (power) indicator will not light up when the 1 (power) switch is pressed, The 1 (power) indicator turns on red. [. . . ] These are related to another group of environmental toxins, PCBs, which are suspected to give rise to similar harm, including reproductive damage in fisheating birds and mammals, due to the bioaccumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. TCO'95 demand requires that plastic components weighing more than 25 grams must not contain organically bound chlorine and bromine. Your choice has provided you with a product developed for professional use. [. . . ]