User manual SONY SDM-HS93

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Then adjust the computer's graphic board so that the horizontal frequency is between 28 ­ 60 kHz (SDMS51), 28 ­ 92 kHz (SDM-HS93/S81), and the vertical frequency is between 48 ­ 75 Hz (SDM-S51), 48 ­ 85 Hz (SDM-HS93/ S81). For more information about the on-screen messages, see "Trouble symptoms and remedies" on page 19. No need for specific drivers The monitor complies with the "DDC" Plug & Play standard and automatically detects all the monitor's information. no specific driver needs to be installed to the computer. The first time you turn on your computer after connecting the monitor, the setup Wizard may appear on the screen. In this case, follow the on-screen instructions. The Plug & Play monitor is automatically selected so that you can use this monitor. Since flickers are unobtrusive on the monitor, you can use it as it is. You do not need to set the vertical frequency to any particular high value. If your computer or graphics board has difficulty communicating with this monitor, install the information file for this monitor using the Windows Monitor Information Disk. This display can be adjusted within the angles shown below. Note You can adjust neither contrast nor brightness when displaying the main menu on the screen. When the monitor receives an input signal, the automatic picture quality adjustment function of this monitor automatically adjusts the picture position, phase, and pitch, and ensures that a clear picture appears on the screen. For more information about this function, see "Automatic picture quality adjustment function" on page 17. For some input signals, this function may not completely adjust the picture position, phase, and pitch. In this case, you can manually set these adjustments according the following instructions. If you manually set these adjustments, they are stored in memory and automatically recalled whenever the monitor receives the same input signals. These settings may have to be repeated if you change the input signal after reconnecting your computer. To reset the automatic picture quality adjustment Select SCREEN RESET and activate it using the RESET menu. See page 16 for more information on using the RESET menu. If the picture is not in the center of the screen, adjust the picture's centering as follows. These settings may have to be repeated if you change the input signal after reconnecting your computer. [. . . ] Try plugging the monitor into a different AC outlet, preferably on a different circuit. Check your graphics board manual for the proper monitor setting. ) and the frequency of the input signal are supported by this monitor (Appendix). Even if the frequency is within the proper range, some graphic boards may have a sync pulse that is too narrow for the monitor to sync correctly. [. . . ]