User manual SONY SDM-M81/B

[. . . ] If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications: SPECIFICATIONS Plug Type Nema-Plug 5-15p Cord Type SVT or SJT, minimum 3 × 18 AWG Length Maximum 15 feet Rating Minimum 7 A, 125 V WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. Dangerously high voltages are present inside the unit. Refer servicing to qualified personnel only. FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Press the M/m buttons to select R (Red) or B (Blue) and press the OK button. Then press the M/m buttons to adjust the color temperature and press the OK button. Since this adjustment changes the color temperature by increasing or decreasing the R and B components with respect to G (green), the G component is fixed. Press the M/m buttons to select , then press the OK button. The new color setting is stored in memory and automatically recalled whenever "User" is selected. The PICTURE ADJUSTMENT menu appears on the screen. Exit MENU 2 1 Press the MENU button. Press the M/m buttons to select (PICTURE ADJUSTMENT) and press the OK button. The PICTURE ADJUSTMENT menu appears on the screen. Press the M/m buttons to select "Smoothing" and press the OK button. The options are displayed on the popup menu. Press the M/m buttons to select the desired mode. You can deactivate this function (See "Auto Adjust" below). Press the OK button. If vertical stripes are observed over the entire screen, adjust the pitch using the following procedures. Press the M/m buttons to select "Pitch" and press the OK button. The "Pitch" adjustment menu appears on the screen. Press the M/m buttons until the vertical stripes disappear. Adjust so that the vertical stripes disappear. 8 These adjustments are stored in memory and automatically recalled when the monitor receives a previously input and registered input signal. 9 Eliminate a shift of the picture caused by the automatic picture quality adjustment (Auto Adjust) 1 Press the MENU button. Press the M/m buttons to select (INPUT SETTING) and press the OK button. The INPUT SETTING menu appears on the screen. Press the M/m buttons to select "Auto Adjust" and press the OK button. The options are displayed on the popup menu. 2 3 10 Click [END] on the screen to turn off the test pattern. 15 Adjust the picture's position manually (H Center /V Center) If the picture is not in the center of the screen, adjust the picture's centering as follows. [. . . ] Monitor buttons do not operate ( appears on the screen). Resolution displayed on the menu screen is incorrect. After turnig off the main power, the 1 (power) indicator stays bright for a while. · Adjust the pitch and phase (analog RGB signal only) (page 15). · Adjust the pitch and phase (analog RGB signal only) (page 15). [. . . ]