User manual SONY SDM-S71

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications: SPECIFICATIONS Plug Type Nema-Plug 5-15p Cord Type SVT or SJT, minimum 3 × 18 AWG Length Maximum 15 feet Rating Minimum 7 A, 125 V To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] You do not need to set the vertical frequency to any particular high value. If your computer or graphics board has difficulty communicating with this monitor, install the information file for this monitor using the Windows Monitor Information Disk. This display can be adjusted within the angles shown below. Grasp the lower sides of the LCD panel, then adjust screen tilt. This display is designed so that you can set it up at a comfortable viewing angle. Adjust the viewing angle of your display according to the height of the desk and chair, and so that light is not reflected from the screen to your eyes. Wait for at least 30 minutes before making adjustments for the best result. You can make numerous adjustments to your monitor using the on-screen menu. See page 12 for more information on using the MENU button. Use the M/m and OK buttons to select the icons in the above main menu illustration. Keep pressing m to scroll down until the icons in menu 9 appear. See page 12 for more information on using the M/m and OK buttons. 1 PHASE (page 13) Select the PHASE menu to adjust the phase when the characters or pictures appear fuzzy throughout the entire screen. adjust the phase after adjusting the pitch. 2 PITCH (page 13) Select the PITCH menu to adjust the pitch when the characters or pictures are unclear in some areas of the screen. Contrast adjustment is made using a separate CONTRAST menu from the main menu (page 11). Press the M/m buttons to make the adjustment, then press the OK button. When you press the OK button, the setting are stored, then the display returns to the previous menu. The menu automatically disappears about 5 seconds after adjusting the contrast. Brightness adjustment is made using a separate BRIGHTNESS menu from the main menu (page 11). Press the MENU button once to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds. [. . . ] If NO INPUT SIGNAL appears on the screen, or the 1 (power) indicator is either orange or alternating between green and orange Picture is ghosting Picture is not centered or sized properly Picture is too small Check that all plugs are firmly seated in their sockets. Note that some video modes do not fill the screen to the edges. The picture is dark It takes a few minutes for the display to become bright after turning on the monitor. Wavy or elliptical pattern (moire) is visible Color is not uniform White does not look white Monitor buttons do not operate ( appears on the screen) The monitor turns off after a while Displaying this monitor's name, serial number, and date of manufacture. [. . . ]