User manual SONY SDM-S81R

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications: SPECIFICATIONS Plug Type Nema-Plug 5-15p Cord Type SVT or SJT, minimum 3 × 18 AWG Length Maximum 15 feet Rating Minimum 7 A, 125 V To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] To reset the automatic picture quality adjustment Select SCREEN RESET and activate it using the RESET menu. See page 14 for more information on using the RESET menu. If the picture is not in the center of the screen, adjust the picture's centering as follows. These settings may have to be repeated if you change the input signal after reconnecting your computer. 4 Move the picture up, down, left, or right until the If horizontal stripes are observed over the entire screen, adjust the phase as the next step. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. You can select the GAMMA setting from "GAMMA 1" ­ "GAMMA 3. Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 6500K. Then press the M/m buttons to select R (Red) or B (Blue) and press the OK button, and then press the M/m buttons to adjust the color temperature and press the OK button. Since this adjustment changes the color temperature by increasing or decreasing the R and B components with respect to G (green), the G component is fixed. If you change the GAMMA setting, the new setting is automatically recalled whenever USER is selected. This adjustment data is automatically stored in memory so that next time, the monitor will function in the same way as when the monitor receives the signals that match one of the factory preset modes. In all modes as above, if the picture is adjusted, the adjustment data is stored as a user mode and automatically recalled whenever the same input signal is received. Note While the automatic picture quality adjustment function is activated, only the 1 (power) switch will operate. Power mode normal operation active off* (deep sleep)** power off Power consumption 25 W (max. Green orange off Power mode normal operation active off* (deep sleep)** power off Power consumption 45 W (max. Green orange off Power mode normal operation active off* (deep sleep)** power off Green orange off When your computer enters the "active off" mode, the input signal is cut and NO INPUT SIGNAL appears on the screen. After 20 seconds, the monitor enters the power saving mode. Before contacting technical support, refer to this section. This indicates that the video signal cable has been disconnected from the currently selected connector. If there is something wrong with the input signal, one of the following messages appears on the screen. This indicates that the input signal is not supported by the monitor's specifications. [. . . ] Your purchase has also contributed to reducing the burden on the environment and also, to the further development of environmentally adapted electronics products. In many countries, environmental labelling has become an established method for encouraging the adaptation of goods and services to the environment. The main problem, as far as computers and other electronics equipment are concerned, is that environmentally harmful substances are used both in the products and during the manufacturing. Since it has not been possible for the majority of electronics equipment to be recycled in a satisfactory way, most of these potentially damaging substances sooner or later enter Nature. [. . . ]