User manual SONY SDM-S95DR

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] When your monitor is in low power consumption mode or power saving mode, no sound comes from the speaker. Wait for at least 30 minutes before making adjustments for the best result. You can make numerous adjustments to your monitor using the on-screen menu. See page 12 for more information on using the MENU button. Use the M(+)/m(­) and OK buttons to select one of the following menus. See page 12 for more information on using the M(+)/m(­) and OK buttons. 1 PHASE (page 13) Select the PHASE menu to adjust the phase when the characters or pictures appear fuzzy throughout the entire screen. adjust the phase after adjusting the pitch. 2 PITCH (page 13) Select the PITCH menu to adjust the pitch when the characters or pictures are unclear in some areas of the screen. This monitor is preset at the factory to display pictures on the screen in full, irrespective of the picture's mode or resolution. You can also view the picture at its actual resolution. However, in this case, the indication in the WIDE STEREO menu does not change. The wide stereo function allows you to increase the soundscape by converting the analog signals into digital. The RESET menu is automatically returned to the main menu after the adjustment data is reset. Then press the M(+)/m(­) buttons to select either ON or OFF. Then press the M(+)/m(­) buttons to adjust the desired light level. English, German, French, Spanish, Italian and Japanese versions of the on-screen menus are available. This monitor is provided with a sensor to detect the brightness of the surrounding area (light sensor). This sensor is used to automatically adjust the brightness of the screen. first press the M(+)/m(­) buttons to select (LIGHT SENSOR) and press the OK button. Then press the M(+)/m(­) buttons to select either ON or OFF. When you select ON, the monitor automatically adjusts the screen brightness according to the brightness of the surroundings. [. . . ] Since all methods of conventional electricity generation have a negative effect on the environment (acidic and climateinfluencing emissions, radioactive waste, etc. Electronics equipment in offices consume an enormous amount of energy since they are often left running continuously. This product meets the requirements for the TCO'95 scheme which provides for international and environmental labelling of personal computers. the labelling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees) , Naturskyddsforeningen (The Swedish Society for Nature Conservation) and NUTEK (The National Board for Industrial and Technical Development in Sweden). [. . . ]