User manual SONY SDM-S95FR

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Keep pressing m to scroll down until the icons in menu 9 appear. See page 12 for more information on using the M/m and OK buttons. 1 PHASE (page 13) Select the PHASE menu to adjust the phase when the characters or pictures appear fuzzy throughout the entire screen. adjust the phase after adjusting the pitch. 2 PITCH (page 13) Select the PITCH menu to adjust the pitch when the characters or pictures are unclear in some areas of the screen. Contrast adjustment is made using a separate CONTRAST menu from the main menu (page 11). Press the M/m buttons to make the adjustment, then press the OK button. When you press the OK button, the setting are stored, then the display returns to the previous menu. The menu automatically disappears about 5 seconds after adjusting the contrast. Brightness adjustment is made using a separate BRIGHTNESS menu from the main menu (page 11). Press the MENU button once to return to normal viewing. If you fine tune the color temperature, the new color setting is stored in memory for USER ADJUSTMENT and automatically recalled whenever USER is selected. Changing the picture size according to the signal (ZOOM) the monitor is set to display the picture on the screen in full , irrespective of the picture's mode or resolution in the default setting. You can also view the picture at its actual aspect ratio or resolution. There are three positions each for the top of the screen and the bottom of the screen, and one for the screen center. 1280 × 1024 resolution signals fill the entire screen and ZOOM is not possible regardless of these settings. Therefore, black bands may appear at the top and bottom of the picture depending on the signal. Sub-SXGA signals are displayed at the center of the screen surrounded by a black frame. If the picture displayed at the FULL2 or FULL1 mode of ZOOM is not smooth, use the picture smoothing function. Note that 1280 × 1024 resolution signals are shown only in REAL mode and SMOOTHING is not possible. GRAPHICS: To make the pictures appear clean. Note When you set the ZOOM menu to REAL, the SMOOTHING menu is not available. [. . . ] Your purchase has also contributed to reducing the burden on the environment and also, to the further development of environmentally adapted electronics products. Up to thirty percent of the plastic in a computer casing can consist of flame retardant substances. These are related to another group of environmental toxins, PCBs, which are suspected to give rise to similar harm, including reproductive damage in fisheating birds and mammals, due to the bioaccumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. [. . . ]