User manual SONY SDM-X93/B

[. . . ] TFT LCD Color Computer Display SDM-X53 SDM-X73 SDM-X93 © 2003 Sony Corporation Owner's Record The model and serial numbers are located at the rear of the unit. Record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. Model No. NOTICE This notice is applicable for USA/Canada only. [. . . ] Also, if necessary, you can fine tune the color temperature. COLOR 9300K 6500K USER AD J U S T 8 Press the OK button. If vertical stripes are observed over the entire screen, adjust the pitch using the following procedures. Press the m/M buttons to select "PITCH" and press the OK button. The "PITCH" adjustment menu appears on the screen. 1 1 2 8 0 x 1 0 2 4 / 6 0Hz EX I T 9 Press the MENU button. Press the m/M buttons to select (COLOR) and press the OK button. Press the m/M buttons to select the desired color temperature and press the OK button. Whites will change from a bluish hue to a reddish hue as the temperature is lowered from 9300K to 6500K. 10 Press the m/M buttons until the vertical stripes disappear. Adjust so that the vertical stripes disappear. 2 3 x Fine tuning the color temperature 11 Click [END] on the screen to turn off the test pattern. SDM-X53: INPUT1 or INPUT2 (DVI-D) SDM-X73/93: INPUT1, INPUT2 or INPUT3 (DVI-D) 1 Press the MENU button. Press the m/M buttons to select (COLOR) and press the OK button. Press the m/M buttons to select "ADJUST" and press the OK button. The fine tuning menu for color temperature appears on the screen. USER R G B A D J U S T MENT 50 50 50 GB x Adjust the picture's position manually (H CENTER /V CENTER) If the picture is not in the center of the screen, adjust the picture's centering as follows. 1 Set the resolution to 1024 × 768 (SDM-X53), 1280 × 1024 (SDM-X73/X93) on the computer. 2 3 2 3 Load the CD-ROM. Start the CD-ROM, select the area and model, and display the test pattern. For Windows Click [Utility] t [Windows]/[Win Utility. exe]. For Macintosh Click [Utility] t [Mac]/[Mac Utility]. Press the m/M buttons to select (SCREEN) and press the OK button. Press the m/M buttons to select "H CENTER" or "V CENTER" and press the OK button. The "H CENTER" adjustment menu or "V CENTER" adjustment menu appears on the screen. Press the m/M buttons to center the test pattern on the screen. Click [END] on the screen to turn off the test pattern. [. . . ] The main problem, as far as computers and other electronics equipment are concerned, is that environmentally harmful substances are used both in the products and during their manufacture. Since it is not so far possible to satisfactorily recycle the majority of electronics equipment, most of these potentially damaging substances sooner or later enter nature. There are also other characteristics of a computer, such as energy consumption levels, that are important from the viewpoints of both the work (internal) and natural (external) environments. Since all methods of electricity generation have a negative effect on the environment (e. g. [. . . ]