User manual SONY SDT-D11000

[. . . ] CAUTION The mains plug on this equipment must be used to disconnect mains power. Please ensure that the socket outlet is installed near the equipment and shall be easily accessible. NOTICE Use the power cord set approved by the appropriate testing organization for the specific countries where this unit is to be used. If you have any questions about this product, you may call: Sony Technical Support, 1-800-588-3847 or write to : Sony Technical Support, 3300 Zanker Road, San Jose, CA 95134, 1940. [. . . ] ⷠMake sure the SCSI connectors are pressed tightly together. ⷠIf this unit is the last (or only) device on the SCSI bus, make sure to connect a SCSI bus terminator to the open connector. ⷠThe total length of the SCSI cable(s) between the host computer and the last device should be less than 3 meters. *1 · To set up the LVD configuration, you need: 1) Host PC with the LVD SCSI Board, 2) only LVD devices on the SCSI bus, and 3) LVD/SE switchable terminator. When using high-speed data transfer with the SDT-D11000, it is recommended that total length of the SCSI cable not exceed 1. Use a SCSI cable with a full pitch 50 pin connector. precautions · Switch off the host computer and peripherals before connecting the SCSI cable. ⷠMake sure the SCSI connectors are pressed tightly together. ⷠIf this unit is the last (or only) device on the SCSI bus, make sure to connect a SCSI bus terminator to the open connector. ⷠThe total length of the SCSI cable(s) between the host computer and the last device should be less than 6 meters. When using high-speed data transfer with the SDT-D9000, it is recommended that total length of the SCSI cable not exceed 3 m. Press the + or ­ buttons to move the number up or down, respectively. As shipped from the factory, the SCSI ID is set to 0. Press the switch buttons, if necessary, to select the SCSI ID number you require. precautions · The SCSI ID must be different from IDs of the other peripherals on the SCSI bus. ⷠAs shipped from the factory, SCSI parity is enabled and Term power is ON. A SCSI bus terminator must be connected to the SCSI bus before use. ⷠBefore changing the SCSI ID setting, be sure to turn off the power with the POWER switch on the front panel. This section describes how to use the DDS drive, and how to handle data cartridges. How to use the DDS Drive 1 Press the POWER switch on the front panel. The POWER indicator should light, and the STATUS, BUSY and TAPE indicators should blink as the self-test is performed. 2 When the three indicators stop blinking, you can insert a data cartridge as 3 Computer software controls the reading and writing of tapes. [. . . ] 1 Load the head cleaning cartridge (DGD15CL) into the DDS drive. 2 After about 10 seconds, cleaning will stop and the cartridge will eject automatically. One head cleaning cartridge can be used about 90 times. Notice Do not rewind the cleaning cartridge and reuse it. [. . . ]