User manual SONY SDT5000

[. . . ] This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. This device requires shielded interface cables to comply with FCC emission limits. [. . . ] Caution Be sure to use only the cartridges designed specifically for DDS (do not use DAT cartridges for music). Lights when data is being transferred through the SCSI interface. This indicator also lights under the following conditions: Drive is reading or writing normally: repeated blinking (same on-off interval). When a DDS cartridge is installed, this indicator lights. This also lights under the following conditions: This indicator also lights under the following conditions: Drive needs cleaning: End of Tape during cleaning: Drive Malfunctioning: repeating long-on, short-off blinking. Push to remove a data cartridge from the drive. After you confirm that you have all of the required accessories for your installation, connect the drive to the host computer, and select the SCSI ID with the rotary switch on the rear panel. When you first open the box, make sure it contains the following items. Contact your supplier if anything is missing or broken. Use a SCSI cable with a 68 pin connector. precautions · Switch off the host computer and peripherals before connecting the SCSI cable. while Reading or writing, the BUSY indicator blinks. Caution Do not push the EJECT button while the BUSY indicator is blinking: to do so may destroy data on the tape. Do not crush the cable or place heavy items on it. If the cable insulation appears worn or broken, do not use the cable. ⷠAlways unplug the cable by holding the plug: never pull the cable itself, as it will break. ⷠIf the drive is not being used for a long time, unplug the cable from the outlet. Do not store or use the drive in locations subject to: · To avoid overheating, install the drive where it will have free air circulation around the case, and do not cover it during operation. The drive can malfunction if the internal temperature rises too high. If the drive is moved from a cool place to a warm place, or if the room temperature suddenly rises, moisture may condense inside the case. After a sudden change in temperature, wait at least one hour before turning the drive on. If the drive is turned on with condensation inside, and a cartridge is installed, the drive or the tape can be damaged. [. . . ] Keep cartridges in their cases when not in the drive. ⷠAvoid storing cartridges in dusty places, in direct sunlight, near heaters or air conditioners, or in humid locations. To keep the DDS drive in top condition, clean the head as needed, using the proper head cleaning cartridge (sold separately). When the head needs cleaning, the STATUS indicator will blink. [. . . ]