User manual SONY SDT7200

[. . . ] How to Use this Guide 6 How to Use this Guide This Guide describes the DDS Drive Unit SDT-S9000/S7000/S7200/S5000/ S5200/S4000E/S2000E , and how to take care of it. Please read it carefully before using the unit, and keep it handy for future reference. the Guide consists of four parts , plus the specifications. Refer to the parts that relate to your use of the drive. [. . . ] Data cartridges used with the SDT-S9000 must be marked with the DDS-1, DDS-2 or DDS-3 logo. The SDT-S7000/S7200/S5000/S5200 can only be used with data catridges marked with the DDS-1 or DDS-2 logo and the SDT7200/S2000E can only be used with data cartridges marked with the DDS-1 logo. CAUTION: Be sure to use only the cartridges designed specifically for DDS (do not use DAT cartridges for music). Push to remove a data cartridge from the drive. This indicator also lights under the following conditions: Drive needs cleaning: End of Tape during cleaning: Drive Malfunctioning: repeating long-on, short-off blinking. This also lights under the following conditions: Inserting and removing a cartridge: Cartridge deteriorated: repeated blinking (same on-off interval). Lights when data is being transferred through the SCSI interface. This indicator also lights under the following conditions: Drive is reading or writing normally: High Humidity: *1 repeated blinking (same on-off interval). Connect the ground terminals of other devices to the unit's frame ground. After you confirm that you have all of the required accessories for your installation, connect the drive to the host computer, and select the SCSI ID with the rotary switch on the rear panel. When you first open the box, make sure it contains the following items. If the cable insulation appears worn or broken, do not use the cable. ⷠAlways unplug the cable by holding the plug: never pull the cable itself, as it will break. ⷠIf the drive is not being used for a long time, unplug the cable from the outlet. Do not store or use the drive in locations subject to: · To avoid overheating, install the drive where it will have free air circulation around the case, and do not cover it during operation. The drive can malfunction if the internal temperature rises too high. If the drive is moved from a cool place to a warm place, or if the room temperature suddenly rises, moisture may condense inside the case. After a sudden change in temperature, wait at least one hour before turning the drive on. If the drive is turned on with condensation inside, and a cartridge is installed, the drive or the tape can be damaged. The drive contains a humidity sensor, which causes the BUSY indicator to blink when the humidity inside the case is too high (see page 10). If this occurs, reduce the humidity in the room with a dehumidifier or air conditioner, or by other means. If the drive behaves abnormally, or if it begins to smell or smoke, immediately unplug it from the wall outlet and contact your supplier for assistance. [. . . ] notice: Do not rewind the cleaning cartridge and reuse it. When you reach the end of the cartridge, dispose of it and buy a new one. 72 MB/s compressed 5 MB/s maximum, asynchronous 10 MB/s maximum, synchronous less than 3 seconds less than 24 seconds less than 20 seconds less than 80 seconds (with 125 m tape) Specifications may be subject to change, in the interest of technological improvement, without notice or obligation. The degree of data compression attained while recording data varies according to system environment and data type. [. . . ]