User manual SONY SDX-1100V

[. . . ] ATTENTION According to the EU Directives related to product safety, EMC and R&TTE the manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. the Authorised Representative is Sony Deutschland GmbH , Hedelfinger Strasse 61 , 70327 Stuttgart , Germany. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. [. . . ] Stored data are automatically checked for compression. Supports reading and writing to data cartridges conforming to the AIT-4 and AIT-3 Ex formats. Stored data are automatically checked for compression. The degree of data compression attained while recording data varies according to system environment and data type. Supports reading and writing to data cartridges conforming to the AIT-3 Ex, AIT-3, and AIT-2 Turbo formats. Stored data are automatically checked for compression. The degree of data compression attained while recording data varies according to system environment and data type. Do not move the drives while they are operating. Avoid exposing the drives to sudden changes from low to high temperatures. This may cause condensation to collect inside the drives. If the ambient temperature should suddenly rise while the drives are turned on, turn them off and wait at least one hour before turning them back on. If you attempt to operate the drives immediately after a sudden increase in temperature, malfunctions may occur. â· Turning off the power to the drives while they are writing to tape may cause the tape to become unreadable. All previously negotiated parameters will be lost, whenever power to the drives is cycled. Keep the original packing materials to facilitate safe transportation of the drives. â· Always remove the tape/media cartridge before moving the drives. After removing the drives from the computer, repack them into their original packing. The SDX-1100V series drives can be used with data cartridges marked with the AIT-5, AIT-4, AIT-3 Ex, or AIT-3 logo. The SDX-900V series drives can be used with data cartridges marked with the AIT-4 or AIT-3 Ex logo. The SDX-800V series drives can be used with data cartridges marked with the AIT-3 Ex, AIT-3, AIT-2 Turbo, AIT-2 (read only), AIT-1 Turbo (read only), AIT-1 (read only), or AIT-E Turbo (read only) logo. [. . . ] While setting the data cartridge, do not turn off the host computer. Set the AIT data cartridge orientation as shown here and insert it into the data cartridge slot. The cartridge can be removed from the SDX-1100V, SDX-900V, and SDX-800V series drives either in response to a SCSI Unload command, or by pressing the EJECT button. When the EJECT button is pressed, the tape is rewound and the cartridge ejected from the slot. [. . . ]