User manual SONY SDX-450V

[. . . ] Make sure you read this manual before using the product. After reading this manual carefully, store it in a safe place. Microsoft and the Microsoft logo are registered trademarks of Microsoft Corporation in the United States and other countries. advanced Intelligent Tape is a trademark of the Sony Corporation. [. . . ] â· This unit does not have a built-in terminator. When connecting this unit to the last terminal of the SCSI bus terminal, attach a terminator to the end of the SCSI cable. 5 When the SCSI bus can be set on the side of the basic processing unit, set the Set the maximum transfer rates as follows according to the number of devices connected to the bus and the SCSI cable length. If you have other specifications at your disposal, use them over the ones below. Only install the device drive if you intend to use Windows 2000 Backup, Windows XP Backup, or Windows Server 2003 Backup (found in their respective System Tools folder). The basic processing unit starts searching for driver files, then the [Driver Files Search Results] screen appears. The [Please select the best match for your hardware from the list below. The device driver that you installed is enabled after you restart the system. The [Please select the best match for your hardware from the list below. When using the ASR (Automated System Recovery*) function in Windows, you must download and install the device driver files from a floppy disk. Prepare a blank floppy disk, and copy the files in the "DeviceDriver" folder on the supplied CD-ROM to the blank floppy disk. Copy the files in the "DeviceDriver" folder so they appear as shown below. *ASR (Automated System Recovery) Supported by Windows XP and Windows Server 2003, this function backs up the OS, system state, hardware composition, and applications on your computer, allowing you to restore them in one step when recovering from a crash. For more details on using this function, refer to the manual for your OS and backup software. The following explains how to handle the Built-In AIT. If you use a data cartridge of other manufacturer, a read/write error may occur. â· While setting the data cartridge, do not turn off the basic processing unit. Orientation as shown here and insert it into the data cartridge slot. Installing the dust cover To avoid damaging the dust cover, it is designed to be easy to install and remove. To install the dust cover, hold it slightly (as illustrated) and insert the pins at both ends of the cover in turn until you hear them clik. 2 Pressing the EJECT button, BuiltIn AIT starts rewinding the tape (this may take a few minutes). When the tape is completely rewound, the data cartridge is automatically ejected from the Built-In AIT. [. . . ] If the cartridge is not ejected even though the EJECT button is pressed, the EJECT function may be locked by the backup software. Turn the power off, and then turn it on again. The drive may have detected a problem and is not allowing the cartridge to be ejected. â· Some drives eject the cartridge when you press and hold the EJECT button for a certain time (five or ten seconds). [. . . ]