User manual SONY SDX-D400C

[. . . ] This device requires shielded interface cables to comply with FCC emission limits. CAUTION The mains plug on this equipment must be used to disconnect mains power. Please ensure that the socket outlet is installed near the equipment and shall be easily accessible. aCHTUNG Zur Trennung vom Netz ist der Netzseker aus der Steckdose zu ziehen , welche sich in der Nähe des Gerätes befinden muß und leicht zugärlich sein soll. [. . . ] Contact your supplier if anything is missing or broken. Use a SCSI cable with a half pitch 68 pin connector. precautions · Switch off the host computer and peripherals before connecting the SCSI cable. Make sure the SCSI connectors are pressed tightly together. If this unit is the last (or only) device on the SCSI bus, make sure to connect a SCSI bus terminator to the open connector. The total length of the SCSI cable(s) between the host computer and the last device should be less than 12 meters. Press the + or buttons to move the number up or down, respectively. As shipped from the factory, the SCSI ID is set to 0. Press the switch buttons, if necessary, to select the SCSI ID number you require. precautions · The SCSI ID must be different from IDs of the other peripherals on the SCSI bus. As shipped from the factory, Term power is ON. A SCSI bus terminator must be connected to the SCSI bus before use. Before changing the SCSI ID setting, be sure to turn off the power with the POWER switch on the front panel. Remove the two slotted screws by using a slotted screwdriver. ) After changing the DIP switch settings, replace access cover and tighten the two slotted screws using a slotted screwdriver. CAUTION Before removing the access cover to change DIP switch settings on the drive, turn off the computer and disconnect the power cord from the unit. Once the DIP switch settings have been changed, replace the access cover using the two original slotted screws provided. Control by host can be disabled when position 8 [DC Control (2)] is ON. This section describes how to use the AIT drive, and how to handle data cartridges. How to use the AIT Drive 1 Press the POWER switch on the front panel. The POWER indicator should light, and the STATUS, BUSY and TAPE indicators (with the SDX-D700C, the TAPE MOTION, CLEANING REQUEST, and REPLACE TAPE indicators) should blink as the selftest is performed. 2 When the three indicators stop blinking, you can insert a data cartridge as 3 Computer software controls the reading and writing of tapes. [. . . ] One head cleaning cartridge can be used about 30 times. Notice Do not rewind the cleaning cartridge and reuse it. When you reach the end of the cartridge, dispose it and buy a new one. 2 MB/s compressed *1 12 MB/s maximum, asynchronous 160 MB/s maximum, synchronous less than 5 seconds less than 24 seconds less than 30 seconds less than 105 seconds (with 230 m tape) Specifications may be subject to change, in the interest of technological improvement, without notice or obligation. [. . . ]