User manual SONY SDX-D800V

[. . . ] The model and serial numbers are located on the bottom. Record the serial number in the space provided below. Refer to them whenever you call upon your dealer regarding this product. Information WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. [. . . ] The SDX-D1100V drive can be used with data cartridges marked with the AIT-5, AIT-4, AIT-3 Ex, or AIT-3 logo. The SDX-D900V drive can be used with data cartridges marked with the AIT-4 or AIT-3 Ex logo. The SDX-D800V drives can be used with data cartridges marked with the AIT-3 Ex, AIT-3, AIT-2 Turbo, AIT-2 (read only), AIT-1 Turbo (read only), AIT-1 (read only), or AIT-E Turbo (read only) logo. The SDX-D700V drive can be used with data cartridges marked with the AIT-3, AIT-2, or AIT-1 logo. The SDX-D500V drive can be used with data cartridges marked with the AIT-2 or AIT-1 logo. The SDX-D400V drive can be used with data cartridges marked with the AIT-1 logo. Do not use cartridges other than the ones described above with this drive. Be sure to use only the cartridges designed specifically for AIT. â· Do not use anything but AIT cartridges with this drive, as doing so can damage the drive. Although commercially available 8 mm videotapes resemble AIT cartridges in appearance, they have entirely different specifications and cannot be used. Example connection to the host computer and other peripheral devices Keep this cover closed when not inserting or removing data cartridges. Push to remove a data cartridge from the drive. After you confirm that you have all of the required accessories for your installation, connect the drive to the host computer, and select the SCSI ID with the rotary switch on the rear panel. When you first open the box, make sure it contains the following items. Contact your supplier if anything is missing or broken. Switch off the host computer and peripherals before connecting the SCSI cable. â· Make sure the SCSI connectors are pressed tightly together. â· If this unit is the last (or only) device on the SCSI bus, make sure to connect a terminator to the appropriate unused SCSI connector. Using an incompatible terminator may damage the unit. â· During LVD SCSI connections, make sure that the total length of the cable(s) connecting the host computer and the last device on the SCSI bus is no longer than 12 meters (39 feet). (During single-end SCSI connections, make sure that the total length of the SCSI cable(s) is no longer than 1. Press the + or buttons to move the number up or down, respectively. [. . . ] â· When finished using the drive, remove the cartridge. Keep cartridges in their cases when not in the drive. â· Avoid storing cartridges in dusty places, in direct sunlight, near heaters or air conditioners, or, in humid locations. To keep the AIT drive in top condition, clean the drive unit as needed using a cleaning cartridge with the AIT logo (sold separately). [. . . ]