User manual SONY SFD200SBP

[. . . ] This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This manual or the software described herein, in whole or in part, may not be reproduced, translated or reduced to any machine readable form without prior written approval from Sony Corporation. iN NO EVENT SHALL SONY CORPORATION BE LIABLE FOR ANY INCIDENTAL , CONSEQUENTIAL OR SPECIAL DAMAGES , WHETHER BASED ON TORT , CONTRACT , OR OTHERWISE , ARISING OUT OF OR IN CONNECTION WITH THIS MANUAL , THE SOFTWARE OR OTHER INFORMATION CONTAINED HEREIN OR THE USE THEREOF. [. . . ] Please ensure that the socket outlet is installed near the equipment and shall be easily accessible. Do not move drive during operation, it may cause a malfunction. Avoid sudden temperature change, it may cause internal condensation. If ambient temperature suddenly changes, wait at least 1 hour before turning unit off. Immediate operation after sudden temperature change may cause malfunction. Always remove diskette before moving unit. If any solid object falls into drive, unplug it and before further operation, have qualified personnel inspect the unit. Do not place foreign objects into DC IN 5V jack. Unplug the AC power cord only via its plug end. Turn off drive unit only by unplugging AC power cord from wall outlet. Avoid heat sources (includes closed vehicles in sunlight) and direct sunlight. (See step 4 on page 12) If using a printer, connect it to drive's printer port. Plug AC power cord into an appropriate outlet. HiFD software must first be installed in order for drive to operate. For Windows to recognize the HiFD drive, it must be powered-on before starting the PC. Before a floppy disk may be used, it must be formatted. Should disk not eject after pressing EJECT, contact Hotline Support listed at the end of this manual. 5" disks are supported in this drive. Their formatted capacity and capabilities are listed below: media Type 2HD 1. 44 MB 2DD 720 kB HiFD 200 MB Capabilities Format, read and write Format, read and write Format, read and write HiFD drive's displayed properties depend on it being poweredon when PC was started. if power was supplied , [Connected] appears in the [Device] of [Properties] box. Port address, IRQ and read/write mode of HiFD also appear in this box. [. . . ] To remove the HiFD drive without shutting down the PC, perform the same steps as above, except instead of selecting Connect button, select Disconnect. The HiFD drive case may be cleaned with a soft cloth slightly moistened with water or a mild detergent. Never use any type of abrasive pad, scouring powder or solvent. Com or the following table before contacting Sony's Hotline Support. [. . . ]