User manual SONY SHRM1

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] SHR-M1 Serial No. Caring for others Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to people around you. Warning If there is lightning when you are using the unit, take off the headphones radio immediately. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Specifications Radio segment Frequency range: FM 87. 5-108 MHz Channel step: 0. 1 MHz Power output: 3. 5 mW + 3. 5 mW Headphone segment Headphone type: Open-air Dynamic Driver unit: ø 30 mm Dome type Input: ø 3. 5 mm stereo mini-jack Maximum input: 100 mW Impedance: 24 ohms (at 1 kHz) Frequency characteristic: 14 to 24, 000 Hz Others Power requirements 1. 5 V DC, one size AAA (R03) battery Mass Approx. cord Accessories supplied Connecting cord (1) Design and specifications are subjected to change without notice. Neckband PRESET (M1~M15) SENS (DX/LOCAL) VOL Display When the radio is not operated, the display goes off. yy , , yy , , yy yy , , , , yy , , y , Earpad AUDIO IN RADIO ON/OFF·i TUNE, +/­ English Battery compartment lid Getting Started Installing the battery (See Fig. A) Open the battery compartment lid on the left earpad (marked L on the outside) and insert one size AAA (R03) battery. Be sure to position the battery according to the polarity indicated in the compartment and insert the battery from the # side first. 3 Adjust VOL (volume). To turn off the radio Set RADIO ON/OFF·i to OFF i. If noise is heard due to too strong reception signal Set SENS to LOCAL. Normally, set SENS to DX. Presetting Your Favorite Stations ­ Preset Tuning You can preset up to 15 of your favorite FM stations. To access the stations, simply select the corresponding PRESET numbers (M1 to M15). Battery life Using Sony alkaline size AAA (LR03) battery: Approx. 27 hours Using Sony size AAA (R03) battery: Approx. 11 hours Replacing the battery When the sound becomes weak or distorted, replace battery with new one. Presetting a Station 1 2 Tune in a station to be preset manually. Keep pressing PRESET (M1-M15) until "M2" flashes and three beeps sound. Example: When the 90. 0 MHz station is preset to "M2". Alarm for Battery Exhaustion When the battery becomes weak, an alarm will beep, and "batt" will flash in the display. When you turn on the power, you can listen to the radio for a while, however, the alarm will beep again. [. . . ] When + is pressed, the frequency is raised. When ­ is pressed, the frequency is lowered. Each time + or ­ is pressed, the frequency is changed in 0. 1 MHz units. [. . . ]