User manual SONY SLV-D910B

[. . . ] The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. installing · Do not install the unit in a confined space such as a book or similar unit. Do not install the unit in an inclined position. Keep the unit and discs away from equipment with strong magnets, such as microwave ovens, or large loudspeakers. [. . . ] Off On Select this when the player is connected to an audio component lacking a built-in DTS decoder. Select this when the player is connected to an audio component with a built-in DTS decoder. Audio DRC (Dynamic Range Control) Makes the sound clear when the volume is turned down when playing a DVD that conforms to "Audio DRC". This affects the output from the following jacks: ­ OUT AUDIO L/R jacks ­ DIGITAL AUDIO OUT (OPTICAL or COAXIAL) jack only when "Dolby Digital" is set to "D-PCM". Makes the low sounds clear even if you turn the volume down. All types of signals including 96 kHz/24 bit are output in their original format. However, if the signal is encrypted for copyright protection purposes, the signal is only output as 48 kHz/16 bit. If you select the surround setting while playing a DVD, the player does not output the following signals from the DIGITAL AUDIO OUT (OPTICAL or COAXIAL) jack. Dolby Digital signals (when you set "Dolby Digital" to "D-PCM" in "AUDIO SETUP" menu) ­ MPEG audio signals · If you connect a component that does not conform to the selected audio signal, a loud noise (or no sound) will come out from the speakers, affecting your ears or causing the speakers to be damaged. Even if you set "48kHz/96kHz PCM" to "96kHz/24bit", the sampling frequency is converted to 48 kHz/16 bit when a "SURROUND" mode (page 76) is selected. The analog audio signals from AUDIO OUT L/R jacks are not affected by "48kHz/96kHz PCM" setting and keep their original sampling frequency level. If you select "Others" in step 4, an additional language menu appears. Press V/v/B/b to select the desired language, then press ENTER. When you select a language that is not recorded on the DVD in step 4, one of the recorded languages will be automatically selected. Playback settings stored in the disc take priority over the DVD SETUP settings and not all the functions described may work. If you change the DVD MENU LANGUAGE setting after playing the disc, press Z to open and close the disc tray to activate the new setting, then play the disc again. Setting the display or sound track language Playback of some DVDs can be limited according to a predetermined level such as the age of the users. Press SET UP when the DVD player is in stop mode, then press V/v to select (DVD) and press ENTER. If you have not entered a password the display for registering a new password appears. Enter a 4-digit password using the number buttons. When you have already registered a password the display for entering the password appears. Enter a 4-digit password using the number buttons. [. . . ] Clean the cabinet, panel and controls with a dry, soft cloth, or a soft cloth slightly moistened with a mild detergent solution. Do not use any type of solvent, such as alcohol or benzine. No picture (or black & white screen appears) Chapter (page 37) Sections of a picture or a music feature that are smaller than titles. The rear channel is stereo and there is a discrete subwoofer channel in this format. [. . . ]